Whirlpool GSFS 5420 WS INSTRUCTION FOR USE
5019 496 98049
GB
GSFS 5420
Quick Reference Guide
Before using the dishwasher, read the user instructions!
(We reserve the right to make technical modifications)
1) Reference programme for energy label in
compliance with EN 50242 regulations;
2) Refer to “User instructions“;
3) Programme data obtained in conformity with
European standard EN 50242. Values may vary in
relation to usage, e.g.: different loads, water
temperatures - above or below 15°C - as well as
water hardness and power supply voltage, etc.
Programme selector knob
Start button
Switches “on” when the
dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the
programme.
On/Off button
Programme chart
Detergent
2)
Consumption
3)
Programmes Loading instructions A B
Litres kWh Minutes
Pre-Rinse cold
Crockery to be washed later. - - 5.0 0.02 10
Rapid 30 min 40°C
Lightly soiled crockery with no
dried-on food.
X - 13.0 0.70 30
Standard
1)
50°C
Normally soiled crockery. X X 16.0 1.05 170
Intensive 70°C
Heavily soiled crockery,
especially pots and pans.
X X 17.0 1.90 135
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Press the
ON
/ OFF button.
Large compartment
A:
With each wash cycle.
Small compartment
B:
For programmes with pre-wash only.
If using combined action dishwasher
tabs, follow the user instructions!
Mechanical indicator
C
.
Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator
D
.
Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Select the desired programme (using the specific button or
knob). The corresponding indicator lamp lights up.
If necessary (and if provided) the corresponding indicator
lamp lights up.
The selected programme
is then memorised (even
in the event of power
failure).
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.
Only after the START button has switched off: Press the
ON /
OFF
button. All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Switch on the appliance
How to fill the
detergent dispenser
CBA
Check the
rinse aid level
Check the regeneration
salt level
Load the racks
Close the door,
turn on the water tap
Select a programme
Select additional
options
Press the START button
“Change programme”
Press the START button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and
press the START button again.
Wash cycle
Switch off the appliance
Shut off the water tap,
unload the racks
Loading...