Whirlpool GSFP 2988-1 WS INSTRUCTION FOR USE

5019 496 90339

GSFP 2988

Quick Reference Guide

Before using the dishwasher, read the user instructions!

(We reserve the right to make technical modifications)

Add regeneration salt

Only add regeneration salt immediately

before starting a wash programme.

Add rinse aid

No water

Check that the appliance fills with water.

Time and failure display

Indicates in hours the time remaining until the star t of

the wash cycle. Switches off at programme start and

indicates the remaining time in hours and minutes.

“F....” Information for the After-Sales Service

“Delayed start” buttons

The wash cycle can be programmed to start after 1 -

24 hours. With each successive touch of the button,

the delayed start indicator increases by 1 hour, and

after 24 returns to 00. Then press the Start button.

The dishwasher will start at the set time.

“Half Load” button

This function can be used with any programme.

The indicator lamp switches on. The wash cycle is

activated for the upper

lower rack

only

When washing without the top rack, press the

“Half Load” button (LED alight).

1) Reference programme for energy label in

compliance with EN 50242 regulations;

2) Refer to “User instructions“;

3) Values may vary in relation to usage, e.g.:

different loads, water temperatures - above or

below 15°C - as well as water hardness and power

supply voltage, etc.

4) The bacteria removal efficiency has been tested

by the Institut Pasteur de Lille (France), based on

the NF EN 13697 standard of November 2001.

5) Programme interruption (e.g. the door being

opened) may compromise the result of the

antibacterial rinse.

On / Off button

Programme selector

On / Off button

Switches “on” when the dishwasher is

operating. Flashes when a fault occurs.

Switches off at the end of the programme.

Indicators

Wash cycle

Pre-Rinse Washing Drying

Programme

end

Options

Programme chart

Detergent

Consumption

Programmes Loading instructions A B

Litres kWh Minutes

Auto Normal 40-55°C

Automatic programme recommended for

routine washes, with no dried-on or burnt

food (not for EN 50242).

X X 10-13 0.8-1.05 50-110

Auto Intensive 60-70°C

Automatic programme recommended for

heavily soiled crockery with dried-on or

burnt food, for example pans and saucepans.

X X 13-20 1.1-2.0 90-140

Pre-Rinse cold

Crockery to be washed later. - - 4.0 0.03 14

Gentle 40°C

Light soiling, for example

glasses and cups.

X - 10.0 0.80 55

Rapid 30 min 40°C

Lightly soiled crockery, with

no dried-on food.

X - 10.0 0.65 30

Eco

50°C

Normally soiled crockery. X X 13.0 1.05 120

Hygiene +

4) 5)

Normally or heavily soiled crockery, with

additional antibacterial action.

X X 13.0 1.50 105

Important information for Test Laboratories:

For detailed information on the EN/Standard loading comparison test, contact the following ad dress:

“nk_customer@email.whirlpool.com”.

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Press the

/ OFF button.

Large compartment

With each wash cycle.

Small compartment

For programmes with pre-wash only.

Mechanical indicator

Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator

Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.

Select the desired programme (using the specific button or

knob). The corresponding indicator lamp lights up.

If necessary (and if provided) the corresponding indicator

lamp lights up.

The selected programme

is then memorised (even

in the event of power

failure).

- Only open the dishwasher if necessary

(Warning: beware of hot steam).

- If the appliance is switched off during

a wash cycle, when switched on

again it will resume the cycle from

where it was interrupted.

Only after the START button has switched off: Press the

ON /

OFF

button. All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

Switch on the appliance

How to fill the

detergent dispenser

CBA

Check the

rinse aid level

Check the regeneration

salt level

Load the racks

Close the door,

turn on the water tap

Select a programme

Select additional

options

Press the START button

“Change programme”

Press the START button for 2 sec. until

the Start indicator lamp switches off;

Select another programme and

press the START button again.

Wash cycle

Switch off the appliance

Shut off the water tap,

unload the racks

+ 2 hidden pages