Whirlpool GKNB 2801, GKNB 2800, GKNB 3200, GKNC 2801 INSTRUCTION FOR USE
6gb33005.fm5 Page 1 Wednesday, February 7, 2001 9:57 AM
PRODUCT SHEET
1.
2
1
3
5
4
Note: the design of drawers and accessories may vary, depending on the model.
Controls
Compartment for freezing
2.
Control unit
3.
Area for drawers and pull-out baskets
4.
Pull-out defrost water drain
5.
Rating plate (on the inside of the appliance).
storage compartment
freezer compartment
GB
A
Digital temperature display.
B
Freezer on/off button.
C
Fast freeze button.
D
Yellow LED: indicates that the fast freeze
function is in operation.
E
Acoustic alarm mute button.
F
Red LED: flashes to indicate that the
temperature in the freezer compartment is
too high.
Switching on
1.
Plug in the appliance
Important
If the digital display shows only an
illuminated dot, press the freezer
on/off button B.
2.
Press button E to mute the
acoustic alarm.
3.
Wait until the temperature
indicated on the digital display
reaches -12°C.
4.
Place food to be frozen and/or
already frozen food in the freezer.
G
Yellow led: control panel locked.
H
Indicator lights: when illuminated, they
indicate that the appliance is operating to
(a)
lower
temperature after settings have been
changed.
I
Adjustment buttons increasing - the internal temperature.
J
Button for locking the control panel.
or to increase
Six horizontal lines appear on the
digital display.
After about 3 seconds, when the
appliance is warm, (internal
temperature above 10°C) only the
two lines in the middle remain
illuminated; red led F illuminates and
the acoustic alarm sounds.
The acoustic alarm stops while the
red led continues to flash.
When the temperature reaches
-12°C, the red led automatically
stops flashing.
(b)
the internal
(a)
for lowering,
(b)
for
5019 603 33005
GB
D F NL E P GR
I
S N FIN
DK
6gb33005.fm5 Page 2 Wednesday, February 7, 2001 9:57 AM
Freezer compartment temperature adjustment
The appliance is normally factory set for optimum operation at a temperature of -18°C.
To alter the internal temperature between -16°C and -24°C, proceed as follows:
•
Press button
temperature previously set.
•
Each time the button is pressed, the temperature setting is changed by 1°C: the value (between
-16°C and -24°C) flashes on the display.
•
Approximately 5 seconds after the button has been pressed for the last time, the set temperature
is stored, the display stops flashing and the current internal temperature is shown on the display.
Note:
The digital display shows internal temperature values between +10°C and -24°C.
In the event of a power failure, selected functions remain stored in the memory.
Fast freezing
The fast freeze function is automatically deactivated after 48 hours.
Alarm signals
I/a
I/b
or
once to adjust the internal temperature: the digital display shows the
Signal Cause Solution
Door open alarm
Temperature
alarm
Temperature
sensor alarm
Prolonged
power failure
alarm
The acoustic alarm is
activated
The acoustic alarm and
red led F are activated
The acoustic alarm is
activated and the display
“SF”
shows
The acoustic alarm and
red led F are activated; the
display flashes, indicating
the highest temperature
reached following the
power failure.
The door has been left open
for more than 1 minute
The internal temperature is
above -12°C
Temperature sensor fault Contact After-sales
Prolonged lack of power
supply, causing the internal
temperature to rise to very
high values at which correct
food storage cannot be
guaranteed
Close the door
Press button E; wait for
the temperature to fall
below -12°C again
service
Press button E; the
display now indicates
the current internal
temperture.
Note:
The temperature alarm may activate if the door is left open for a prolonged period of time or following
the introduction of fresh food in the freezer compartment; this temporary rise in temperature does not
affect the storage of already frozen food in any way.
Control panel lock function
This function prevents anyone inadvertently altering operating parameters or switching the appliance
off. To lock the control panel:
until the yellow led G lights up. To unlock the control panel, press the same buttons again until the
yellow led G switches off.
press button J and then button B
and hold down for about 5 seconds,
5019 603 33005
GB
D F NL E P GR
I
S N FIN
DK
Loading...