Whirlpool ETPV 6950 IN PROGRAM CHART

ETPV 9500 IN PRODUCT DESCRIPTION SHEET

GB

1. Front left cooking zone
Ø 145mm

2. Rear left double cooking zone
Ø 265/170mm

3. Rear middle cooking zone
Ø 180mm

4. Rear right cooking zone
Ø 145mm

5. Front right double cooking zone
Ø 180/120mm

6. Display

Important:
To avoid permanently damaging the glass ceramic

hob, do not use:

- pots with bottoms that are not perfectly flat

- metal pots with enamelled bottoms.

Any aesthetic defects (scratches, marks etc.) must be reported at the time of installation.
Two or more persons are required for moving and installing the hob.
Otherwise the back or other parts may become damaged.

COOKING HOB DIMENSIONS (mm)

5019 419 66027

USING THE HOB

1-2-3-

Power level display 8 Timer activation buttoni

4-5

6 Timer display (in minutes) 10 Safety lock button

Second cooking zone (of corresponding

7-9

hotplate) activation button

11 ON/OFF button

Press the ON/OFF button to switch on the hob. For 3 seconds the display will show the LED at the

button . The hob automatically switches off if no cooking zone is switched on within 10 seconds.
Press the corresponding + or - button within 10 seconds to switch on the element to be used.
Then adjust the temperature with the +/- buttons.
To switch off an element, press the - button until “0” is displayed. The corresponding LED goes off
within 10 seconds.
The + and - buttons can also be pressed at the same time to switch off an element.

To switch off the hob, press the ON/OFF button. If all the elements are set to “0”, the hob will
switch off after 10 seconds.

Whenever an object is placed on the hob control panel or in case of splashing of liquids (water, milk, etc.), the
hob automatically switches off and a warning buzzer will sound for 3 seconds every 30 seconds, with the
letter “F” and “L” appearing on the display.
If the hob has elements in the double cooking zone, switch on the second zone by pressing the

corresponding symbol for 3 seconds. After switching on the second element, adjust the
temperature with the +/- buttons.

When an element is switched off and the temperature is higher than 50°C, the LED H (Hot, very hot)
next to the + button lights up. The LED H (Hot, very hot) will stay on until the hob has cooled down to
a safe temperature.
The booster function can be used to rapidly reach the required temperature. To activate this function,
switch on the required cooking zone with the corresponding + button. The display will show the
number 9 followed by a dot indicating that the booster function is on.
At this point, set the required cooking level within 10 seconds (normal cooking 5/6).
If no cooking zone is selected within 10 seconds, after the booster has been activated, the decimal point
goes off and the booster is deactivated.