Whirlpool DWF B40W INSTRUCTION FOR USE
Before using the dishwasher, read the user instructions!
DWF B40
Indicators
Quick Reference Guide
On button
Off button
Programme selection button
Start button
Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Options
GB
“Half load” button
The half load cycle can be used for
the upper and lower rack. Select the
required programme then press the
“Half Load” button. The light comes
on and goes off at the end of the
programme.
The “Half Load” function can be used
with programmes marked with an *.
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Programme chart
Programmes Loading instructions A B
Pre-Rinse cold
Quickwash 40°C
Normal
Normal
1) *)
*)
Intensive 70°C
1) Reference programme for energy label in compliance with
EN 50242 regulations;
2) Refer to “User instructions”;
Crockery to be washed later. - - 5.0 0.02 10
Lightly soiled crockery, with no dried-on
food.
Normally soiled crockery. X X 16.0 1.05 140
50°C
Normally or heavily soiled crockery. X X 16.0 1.65 100
65°C
Recommended programme for heavily soiled
crockery, especially suitable for pans and
saucepans.
Detergent
X - 13.0 0.70 30
X X 17.0 1.90 135
3) Program data obtained in conformity with European
standard EN 50242. Values may vary in relation to usage,
e.g.: different loads, water temperatures - above or below
15°C - as well as water hardness and power supply
voltage, etc.
2)
Consumption
Litres kWh Minutes
5019 696 98013
(We reserve the right to make technical modifications)
IK/I/FD/GB
3)
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Open the door,
switch on the appliance
How to fill the
detergent dispenser
Check the rinse aid level
Check the regeneration
salt level
Load the racks
Select a programme
Select options
Press the ON button.
Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash
only.
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener system
only .
Mechanical indicator D. Electric indicator
on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Press the button until the desired programme lights up.
If necessary (and if provided)
the corresponding indicator lamp lights up.
A:
ABC
B:
Press the Start button
Turn on the water tap
close the dishwasher door
Wash cycle
Switch off the appliance
Turn off the water tap,
unload the racks
The selected programme is
then memorised (even in the
event of power failure).
At the end of the programme an acoustic signal will sound.
Only after the ST ART button has switched off:
All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
“Change programme”
Press the ST ART button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and
press the START button again.
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.
press the OFF button
.
IK/II/FD/GB
Loading...