Whirlpool DWF A10 S INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

DWF A10

Quick Reference Guide

Programme selector knob

Mains

On / Off

Start button

Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Programme chart

Programmes Loading instructions A B Litres kWh Minutes

Pre-Rinse cold

Rapid 40°C

Normal

Intensive 70°C

1) Reference programme for energy label in c ompliance with EN 50242 regulations;

2) Refer to “User instructions“;

Crockery to be washed later. - - 8.0 0.02 10

Lightly soiled crockery with no dried-on food.

Normally soiled crockery. X X 19.0 1.05 160

50°C

Recommended programme for heavily soiled crockery, especially suitable for pans and saucepans.

Detergent

X - 16.0 0.70 30

X X 20.0 1.90 135

3) Programme data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc.

Consumption

5019 696 98032

(We reserve the right to make technical modifications)

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the

detergent dispenser

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Close the dishwasher door,

turn on the water tap

Select a programme

Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it).

Large compartment With each wash cycle. Small compartment For programmes with pre-wash only. If using combined action dishwasher tabs, follow the user instructions!

Mechanical indicator C. Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator D. Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

Select the desired programme. The corresponding indicator lamp comes on.

ABC

Select options

Press the Start button

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme is then memorised (even in the event of power failure).

Only after the START button has switched off: Access the knob (in case of retractable knob, press and then release the knob).

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme”

Press the ST ART button for 2 sec. until the Start indicator lamp switches off;

Select another programme and press the START button again.

- Only open the dishwasher if necessary (Warning: beware of hot steam).

- If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.

+ 2 hidden pages