Whirlpool DWF 902 W (700,193,03) INSTRUCTION FOR USE

DWF 902

PROGRAMME CHART

On button

Off button

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt.

Pre-rinse

(small

Detergent

compartment)

Washing

(large

Water (Liter)

Programme Symbol and

temperature

Pre-rinse

Rapid 50° C

Universal 65° C

Normal 65° C

Intensive 70° C

*) Values for normal conditions. Values may vary in relation to usage, e.g. different loads, water temperatures, water hardness and power supply voltage.

Crockery to be washed later. - - 5.0 0.02 9 4.2 0.02 9

Lightly soiled crockery with no dried-on food. - + 12.5 0.90 65 10.5 0.85 63

Normally soiled crockery. - + 14.0 1.50 73 12.0 1.40 71

Normally or heavily soiled crockery. + + 20.0 1.63 98 18.0 1.55 90

Normal or heavily soiled pans and saucepans. + + 22.5 1.75 93 19.0 1.64 90

Load

Crockery and cutlery

compartment)

Programme selector button

Start button indicator lamp

Switches on when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Half Load / Multizone Button

Load the upper or lower rack only. This function can be used with any programme.

Consumption *

Normal load

Energy

(kWh)

Time

(Min.)

Consumption *

Half Load

Water (Liter)

Energy

(kWh)

Time

(Min.)

1) Reference programme for Test Institute and energy-label.

(We reserve the right to make technical modifications)

5019 100 92106

Quick reference guide

Daily check list

1. Arrange crockery so that items do not touch each other.

2. Load cups at an inclination to facilitate water circulation.

3. In general, place the cutlery in the basket with the handles positioned downwards, but ensure that sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards.

4. Make sure the water jet can reach all loaded items and that the spray arms turn freely.

5. Turn on the water supply tap before starting the dishwasher.

Important:

• Switch off the dishwasher once the “Start” indicator lamp has switched off. If the dishwasher is turned off during the washing programme, it will start again from the same point in the programme when it is turned back on.

• If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off ! Refer to the “Troubleshooting Guide” in these user instructions to remedy any problems.

• If a regeneration salt is to be added, IMMEDIATELY start a washing programme, in order to eliminate any residual salt.

• Sometimes even when the regeneration salt container is full, the corresponding indicator lamp may illuminate during the first wash cycle.

Crockery holder:

• Down: cups and long-stemmed glasses.

• Up: plates.

Upper rack

Half Load / Multizone

If only the upper rack is to be filled, remove the cultery basket from the lower rack and place it in the upper one.

Height adjustment:

(The dishwasher is delivered with the upper rack in the top position).

The dishwasher is delivered with the upper rack in the top position.

• To lower: pull out the two side handles and gently lower the rack.

• To raise: pull up the two side handles until the rack clicks into place.

• The rack must be level on both sides.

Lower rack

Half Load / Multizone:

Loading the lower rack only: greater washing power, especially for plates and saucepans.

Cutlery basket:

The cutlery basket can be removed to increase available space.

Plate holders:

• The plate holders may be removed to increase available space.

• To remove: pull the handle up.

• To reposition: simply insert in the required position (normal or crosswise).