Whirlpool DWF 442 PROGRAM CHART

GB

DWF 442

PROGRAMME CHART

On button

Off button

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt.

Programme
Symbol and

temperature

Pre-wash

Rapid 50° C

Universal 65° C
Normal 65° C

Intensive 70° C

*) Values for normal conditions Values may vary in relation to usage, e.g.: different loads, water temperatures, water hardness and power supply voltage.

Crockery to be washed later.
Lightly soiled crockery with no dried-on food.
Normally soiled crockery.

1)

Normally or heavily soiled crockery.
Heavily soiled pans and saucepans.

Load

Crockery and cutlery

compartment)

Detergent

Pre-rinse

(small

- - 5,0 0,02 9 4,2 0,02 9

- + 12,5 0,90 65 10,5 0,85 63

- + 14,0 1,50 73 12,0 1,40 71
+ + 20,0 1,63 98 18,0 1,55 90
+ + 22,5 1,75 93 19,0 1,64 90

Washing

(large

compartment)

Programme selector button

Start button indicator lamp

Switches on when the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.

Half Load button / Multizone

Load the upper
This function can be used with any programme.

or

Consumption *

Normal load

Water
(Liter)

Energy

(kWh)

Time

(Min.)

lower rack only.

Consumption *

Half Load

Water

Energy

(Liter)

(kWh)

Time

(Min.)

1) Reference programme for Test In stit ute and en ergy l abel .

(We reserve the right to make technical modifications)

5019 100 92104

Quick Reference Guide

GB

Daily check list

1. Arrange crockery so that items do
not touch each other.

2. Load cups at an inclination to
facilitate water circulation.

3. In general, place the cutlery in the
basket with the handles positioned
downwards, but ensure that sharp
knives and forks that might cause
injury are placed in the basket with
the handles positioned upwards.

4. Make sure the water je t can reach
all loaded items and that the spray
arms turn freely.

5. Turn on the water supply tap before
starting the dishwasher.

Important

• Switch off the dishwasher once the
“Start” indicator lamp has

switched off If you switch off the
dishwasher during a wash cycle,
when switched on again the
dishwasher resumes the cycle from
where it was interrupted.

• If a fault occurs or you wish to
change the current programme,
press the “START” but ton for about
5 seconds until the Start indicator
lamp switches off ! Refer to the
“Troubleshooting Guide” in these
user instructions to remedy any
problems.

•

If regeneration salt is to be
added, IMMEDIATELY

start a
washing programme, to
eliminate any residual salt

• Sometimes even when the
regeneration salt container is full,
the corresponding indicator
lamp may illuminate during the
first wash cycle.

.

Crockery holders:

• Down: cups and long-stemmed
glasses.

• Up: plates.

Upper rack

Half load button / Multizone:

If only the upper rack is to be loaded,
remove the cutlery basket from the
lower rach and place it in the upper
one.

Height adjustment:

(The dishwasher is delivered with the
upper rack in the top position).

The rack height can also be changed
when loaded.

• To lower: pull out the two side
handles and gently lower the rack.

• To raise: pull up the two side
handles until the rack clicks into
place.

• The rack must be level on both
sides.

Lower rack

Half load button / Multizone:

Loading the lower rack only:
greater washing power, particularly for
plates and saucepans.

Cutlery basket:

The cutlery basket can be removed to
increase available space.

Plate holders:

• The plate holders may be removed
to increase available space.

• To remove: pull the handle up.

• To reposition: simply insert in the
required position (normal or
crosswise).