Whirlpool DWF 402 W PROGRAM CHART

GB

DWF 402

Important:

• If a faul t occurs or you wish to change the current programme , p ress
the “START” button for about 5 seconds until the Start indicator lamp
switches off! Refer to the “Troubleshooting guide” in these user
instructions to remedy any problems.

• Sometimes even when the regeneration salt container is full, the
corresponding indicator lamp may illuminate during the first wash
cycle.

• Switch off the dishwasher once the “Start” indicator lamp has
switched off. If you switch off the dishwasher during a wash cycle,
when switched on again the dishwasher resumes the cycle from where
it was interrupted.

PROGRAMME CHART

Start button indicator lamp:

Switches “on” when the dishwasher is
operating.

Flashes when a fault occurs.
Switches “off” at the end of the programme.

Programme selector
On
Off

Programme

Symbol

Pre-rinse

Rapid 50 °C

Daily 65 °C

Normal 65 °C 1)

Intensive 70 °C



Crockery to be washed later. - - ­Lightly soiled crockery with no dried-on food. 55 °C - +
Normally soiled crockery. 65 °C - +
Normally or heavily soiled crockery. 65 °C + +
Heavily soiled pans and saucepans. 65 °C + +

Load

Crockery and cutlery

Rinse aid

Add rinse aid

Regeneration salt

Add regeneration salt

Final rinse

temperature:

Detergent dispenser:

+) with pre-rinse

-) without pre-rinse

** small

compartment

large

compartment

Half load

Load the upper or lower rack only.

Consumption ***

Normal load Half load

Water
(Liter)

12.5 0.90 65 10.5 0.85 63

14.0 1.50 73 12 1.40 71

22.0 1.64 93 18 1.55 90

22.5 1.75 93 19 1.64 90

Energy

(kWh)

5.0 0.02 9 4.2 0.02 9

Time

(Min.)

Water
(Liter)

Energy

(kWh)

(Min.)

Time

*) Recommended programme for use with “new generation” enzyme-based detergents.
**) For pre-rinse.
***) Values for normal conditions. Values may vary in relation to usage, e.g.: different loads, water temperatures, water hardness and power supply voltage.

1) Consult the programme on the energy data plate.

5019 100 92013

Quick reference guide

Also refer to the "Dishwasher loading instructions" which contain detailed information and useful tips.

GB

Daily check list:

1. Turn on the tap.

2. Arrange crockery so that items do not
touch each other.

3. Make sure the water jet can reach all
loaded items and that the spray arms
turn freely.

4. Fill the detergent dispenser and
check the salt and rinse aid levels.

5. Close the dishwasher door.

Tips:

Crockery:

• Load crockery upside down on the
racks.

Cutlery:

• The cutlery basket can be removed
to increase available space.

• Place the cutlery unsorted in the
cutlery basket with the handles
positioned downwards.

• To avoid the risk of injury on sharp
knives and forks, cutlery can also be
placed in the basket with the handles
positioned upwards.

Cups:

• Load cups at an angle to facilitate
water circulation.

Silver cutlery:

• Always hand wash silver cutlery
immediately after use. Follow the
detergent manufacturer's directions
on the detergent pack.

Important:

• Only load the appliance with
dishwasher-proof crockery and
cooking utensils.

• Certain wooden and aluminium
articles may discolour.

• Glued, plastic utensils may be heat
sensitive.

• Tin may become dull.

• Decorated crockery (unglazed) may

fade.

• Glasses may become dull.

Crockery holder:

• Down: cups and long-stemmed
glasses.

• Up: plates.

Half load:

Loading the upper rack

• Upper rack: the cutlery baskets may
be inserted or removed as required.

• Remove the cutlery baskets from the
lower rack.

only

.

Plate holders:

• The plate holders may be removed to
increase available space.

• To remove, pull the handle up.

• To reposition, simply insert in the

required position (normal or
crosswise).

Upper rack

Cutlery basket:

Loading the upper rack

for a half load.

Lower rack

Height adjustment:

(The dishwasher is delivered with the
upper rack in the top position).
The rack height can also be changed
when loaded.

• To lower: pull out the two side handles
and gently lower the rack.

• To raise: pull up the two side handles
until the rack clicks into place.

• The rack must be level on both
sides.

Half load:

Loading the lower rack

• Greater washing power for plates and
saucepans.

• The cutlery baskets may be inserted
or removed as required.

only

.

Cutlery basket: the cutlery basket
may be removed to increase
available space.