Whirlpool DW 930/1 PROGRAM CHART

Before using the dishwasher, read the user instructions!

DW 930

Quick Reference Guide

On button

Off button

Programme selection button

Start button

Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Programme chart

Programmes Loading instructions A B Litres kWh Minutes

Quickwash 40°C

Normal

Intensive 70°C

1) Reference programme for energy label in compliance with EN 50242 regulations;

2) Refer to “User instructions”;

Lightly soiled crockery with no dried-on food.

Normally or heavily soiled crockery. X X 19.0 1.24 133

50°C

Recommended programme for heavily soiled crockery, especially suitable for pans and saucepans.

Detergent

X - 16.0 0.70 30

X X 20.0 1.90 125

3) Program data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g.: different loads, water temperatures - above or be low 15°C - as well as water hardness and power supply voltage, etc.

Consumption

5019 696 93147

(We reserve the right to make technical modifications)

NEU/I/FD/GB

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Open the door,

switch on the appliance

How to fill the

detergent dispenser

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Select a programme

Select options

Press the ON button.

Large compartment A: With each wash cycle. Small compartment B: For programmes with pre-wash

only.

Mechanical indicator C. Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator D. Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up. Press the button until the desired programme lights up.

If necessary (and if provided) the corresponding indicator lamp lights up.

Press the Start button

Turn on the water tap

close the dishwasher door

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

The selected programme is then memorised (even in the event of power failure).

At the end of the programme an acoustic signal will sound. Only after the START button has switched off: press the OFF button. All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme”

Press the START button for 2 sec. until the Start indicator lamp switches off;

Select another programme and press the START button again.

- Only open the dishwasher if necessary (Warning: beware of hot steam).

- If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.

+ 2 hidden pages