Whirlpool BHDH2500FS0 Use And Care Manual
DEHUMIDIFIER
Use & Care Guide
Full light Humldlstat
Control panel
Front grille
FRONT VIEW
Rear grille Evaporator toll
(on cabinet under
Dreln hose
water pan)
connection
REAR VIEW
Part No. 1169993
1% IT-t
&tents
Page
Important Safety Instructions ........................ 2
Before Using Your Dehumldifler .................... 3
Install properly ................................................ 3
Electrical requirements.. .................................
4
Using Your Dehumidifier ................................ 5
25, 30, 40, and 50 pint models ....................... 6
Setting the water level adjustment ................. 7
Water disposal methods ................................. 8
Caring for Your Dehumidifier ......................... 9
Troubleshooting.. ...........................................
1 1
Requesting Assistance or Senrice .............. 12
Warranty .........................................................
14
Thank you for buying this dehumidifier. Please
complete the form below. Have this information
ready if you need service or call with a question.
l
Copy model and serial numbers from label (see
diagram on front cover) and purchase date from
sales slip.
l
Keep this book and sales slip together in a
handy place.
Serial Number
Purchase Date
Service Company Phone Number
important Safety
instructions
To reduce the risk of fire, electrical shock,
or personal Injury when using your dehumidifier, follow these bask precautions:
l
Read all lnstructlons before using your
dehumidifier.
l
Complete the Installation and electrical
requirements as described in “Before
Using Your Dehumidifier” on pages 3
and 4.
l
Never allow children to operate or play
with the dehumidifier.
l
Never clean dehumidifier parts with
flammable fluids. The fumes can create a
fire hazard or explosion.
. FOR YOUR SAFETY
l
DO NOT STORE OR USE GASOUNE OR
OTHER FLAMMABLE VAPORS AND
UQUIDS IN THE VlClNlTY OF THIS OR ANY
OTHER APPUANCE. THE FUMES CAN
CREATE A FIRE HAZARD OR EXPLOSION.
It is your responsibility to be sure your dehu-
midifier:
l
Is properly installed on a floor, table, or shetf
that is reasonably level and strong enough to
support unit with a full pan of water. Unit can
weigh between 22.5 kg (50 Ibs.) and 33.8 kg
(75 lbs.), depending on the amount of water
collected in the pan.
l
Is the correct size for the area you want to
dehumidify.
l
Is connected to the proper kind of outlet, with
the correct electrical supply and grounding.
(See “Electrical requirements” on page 4.)
l
Is used only for jobs expected of home
dehumidifiers.
l
Is not used by children or anyone unable to
operate it properly.
l
Is properly maintained.
l
Is used in an area where the room temperature will not fall below 18.3% (65°F).
- SAVE THESE INSTRUCTIONS -
DO NOT REMOVE TECH SHEET from inside
cabinet. Your service technician will need this
information.
Before Using Your Dehumidifier
Install properly
12
lnchw
Personal Injury Hazard
Because your dehumidifier weighs between 225 kg (50 Ibs.) and 33.8 kg (75 Ibs.),
depending on the amount of water collected in the pan, R is recommended that
you use proper lifting techniques when
lifting or moving your unit. Failure to do so
could result in personal injury.
1. Allow at least 30.5 cm (12 inches) of space on
all sides of the unit for good air circulation.
:
,
2. Install the unit on a floor, table, or shelf. When
installing the unit on a table or shelf, be sure it
is strong enough to support the unit with a full
pan of water. A table or shelf may be a better
position from which to handle the water pan.
Do not sit or stand on this product. The height
of a table or shelf may help prevent icing of
coils due to colder air near the floor (such as
can be found in a basement).
3. Keep all outside doors, windows, and other
openings closed when dehumidifier is operating. Humid outdoor air will add to the
dehumidifier’s operating load.
4. The water pan must be properly posi-
tioned, on the hangers inside the cabinet,
when dehumidifier is operating in order for the
automatic shutoff to operate correctly.
5. On most models, two rollers let you easily
move the dehumidifier. Remove the water
pan. Tilt unit forward and roll to another
position.
lf your model does not have rollers, pick up
the unit to move it to another position.
3
Before Using Your Dehumidifier
Continued
Electrical requirements
OBSERVE ALL GOVERNING CODES AND
ORDINANCES.
Electrical ground is required on this
appliance.
A 115 volt, 50 Hz., AC only, 15 ampere fused
electrical supply is recommended. (Time delay
fuse or circuit breaker is recommended.) It is
recommended that a separate circuit sewing only
this appliance be provided. Do not use an
extension cord.
DO NOT, UNDER ANY CIRCUMSTANCES,
REMOVE THE POWER SUPPLY CORD
GROUND PRONG.
Recommended grounding method
For your personal safety, this appliance must be
grounded. This appliance is equipped with a
power supply cord having a 3prong grounding
plug. To minimize possible shock hazard, the
cord must be plugged into a mating grounding
type wall receptacle, grounded in accordance
with all local codes and ordinances. If a mating
wall receptacle is not available, it is the responsibility of the customer to have a properly
grounded, 3-prong wall receptacle installed by a
qualified electrician.
4
Using Your Dehumidifier
You will use your dehumidifier more during
months when you’re not heating your home.
However, your dehumidifier can help prevent
excessive moisture and keep you comfortable all
year long, in any area of your home.
l
Use in a basement to help prevent moisture
damage.
l
Use in cooking, laundry, bathing, and
dishwashing areas which have excess moisture.
l
Use to prevent moisture damage anywhere
books or valuables are stored.
5
Using Your Dehumidifier
Contmued
25,30,40, and 50 pint
models
r
PAN FULL
HUMIDISTAT
0
I
.
PAN FULL
HUMIDISTAT
0
r
PAN FULL
0
Control panel
These units have a control panel containing two
controls -the Pan Full Light and the Humidistat.
Pan Full Light -This light glows when the water
pan is full and needs to be emptied.
Humidistat - This controls the amount of
moisture left in the room. When the humidity in
the room increases, the unit automatically starts.
When the humidity decreases to the selected
level, the unit automatically stops. The unit will
run constantly when control is set to DRYEST.
Unit operation
1.
Turn Humidistat to OFF. Plug power supply
cord into electrical outlet. Be sure to use the
correct grounding technique. (See page 4.)
Turn the Humidistat toward DRYEST for
normal operation.
The Humidistat can be set anywhere
between OFF and DRYEST. lf you need more
dehumidification, turn the Humidistat toward
DRYEST. lf you need less dehumidification,
turn the Humidistat toward OFF.
Stop the unit manually by turning Humidistat
right to OFF.
/
NOTE: The dehumidifier will run continuously
when the control is set to DRYEST.
Water kvel
adJustmalt
\
Water level
control switch
c
\
@
//
&y 0
4. 6
3\
’ --a
e’
Normal fill
screw
Msxknum fill
Ddcw control
NOTE: Do not operate dehumidifiir at tempera-
tures below 18.3% (65°F). The coils may
become iced over and unit will not operate
Properly.
Your dehumidifier is equipped with a feature to
help you get the most comfort from your new
appliince by permitting it to operate down to
18.3% (65°F). If your dehumidifier runs when
room temperature and humidity conditions are
low, frost can form on its evaporator coil. This
interferes with proper operation.
The De-icer Control senses frost buildup on
the evaporator coil and automatically shuts off
the compressor. The fan conttnues to run,
drawing air across the coil, and melting the frost.
When the coil is defrosted, the compressor
automatically restarts, and dehumidifying
resumes.
Setting the water level
adjustment
The Water Level Adjustment can be set in two
positions to turn off the unit automatically when
the pan is full. This prevents the danger of
overflow.
Pan must be in proper position for Water Level
Control Switch to work.
l
NORMAL FILL - set Water Level Adjustment
to the indentation on the left side. The water
pan and water will weigh approximately 7.2 kg
(16 Ibs.) and water pan will be ‘h full.
l
MAXIMUM FILL - set Water Level Adjustment
to the raised area on the right side. The water
pan and water will weigh approximately 10.8 kg
(24 Ibs.) and water pan will be % full.
The Water Level Control Switch will automatically
turn off the dehumidifier at the fill level you
selected when pan ia property placed. Loosen
the screw to move the Water Level Adjustment.
Retighten screw when adjusted to desired
setting.
7
Water disposal methods
Personal Injury Hazard
Do not use the water that collects in the
water pan for drinking purposes. R is not
sanitary and could cause Illness.
There are three methods of disposing of water.
1. Empty pan manually.
When pan is full, remove it, empty it into a
large sink or tub, and put it back in place. Be
sure pan Is properly placed so the Water
Level Control Switch will work to shut off
the unit automatically.
2. Place unit directly over drain.
Pan has a threaded hose connection which
can be left open. Cut out opening with a knife
or 19 mm (“h’) wood drill. Once opened, hose
connection will continually drain water from the
pan. Be sure to keep unit directly over a drain.
3. Attach garden hose to the threaded hose
connection to carry water to drain.
l
Pan has a threaded hose connection which
can be left open. Cut out opening with a
knife or 19 mm (%“) wood drill.
l
Attach garden hose. Be sure hose does not
kink or bend. It should lie flat from unit to
drain. (Hose is not included.)
l
Once hose connection is opened, pan will
continually drain through the hose. Be sure
to keep hose flat and in drain.
Caring for Your Dehumidifier
Your dehumidifier is designed to serve you yearround. lt needs practically no attention. However,
you should check your dehumidifier and inspect
the coils annually.
You may call a service company to perform this
annual checkup. (Cost of annual inspection is the
owner’s responsibility.)
OR
tf you are familiar with electrical appliances and
their functions, below we have listed instructions
which would allow you to do the inspection and
maintenance yourself. However, we suggest you
contact a qualified service company to perform
this service, as we will not be held responsible for
any personal injury or damages, should you elect
to service this unit.
Electrkal Shock and
Personal Injury Hazard
l
Disconnect Power supply cord from
receptacle before performing any maintenance. Failure to do so could result in
electrical shock
l
Be careful when cleaning the coils. Fins
are sharp. Failure to do so could result In
personal Injury.
1. Disconnect power supply cord.
2. To remove outer cabinet:
l
To take off the plastic front grille, remove the
two screws at the bottom. Drop grille down
and take out.
l
Remove the socket head screws on each
side of cabinet.
Socket head
screws
(on sides of cabinet)
Loading...