Page 1
Machine operation
Sort laundry according to
care symbols
Do not tumble dry
Suitable for tumble drying -
Suitable for tumble drying
at low temperatures
Prepare laundry
Load dryer
Select programme
Select options
(if available)
Start dryer
Programme end -
unload dryer
Switch dryer off
Additional information (including troubleshooting and service) can be found in the individual sections of the
Instructions For Use.
Sort laundry by:
Material thickness: whenever the load is greater than the dryer can handle,
separate laundry according to weight (e.g. dry towels and thin underwear separately).
Ty p e o f m a t e r i a l : cotton (linen); synthetic textiles (easy care).
Dryness level: cupboard dry, iron dry etc.
Do not tumble dry: woollens, silk, nylon stockings, delicate embroidery, fabrics with
metallic decorations, bulky items such as sleeping bags or pillows.
Check that all fastenings are closed and that pockets are empty. Ensure that there are
no cigarette lighters in the wash. Turn laundry inside out.
Place laundry loosely in the drum to achieve even drying throughout. Then close the
door.
Select the required drying programme by turning the programme selector knob (for
information, refer to programme table).
Select the required option by pressing the corresponding button.
The indicator lamp above the relevant button lights up to confirm your selection.
A fast blinking LED indicates that an invalid selection has been made (incompatible
option). Press the button again to cancel the option.
Set the programme selector knob to “Off” (“O”).
Cleaning the lint filter: open door, pull lint filter up and out of machine and open it. Brush lint using a soft brush or your
fingertips. Close lint filter and push firmly back into place (more detailed informations are given in the Instructions For Use).
Emptying the water container: pull container out by the handle and empty. Replace the container when empty by pushing it
completely back into place.
Please note: only use additives/plastic items specified as dryer safe and rinse items that have been treated with stain remover
thoroughly in plenty of water before drying. Never dry rubber objects or objects stained with vegetable oils in the dryer.
The Manufacturer is not liable for any damage to laundry resulting from inadequate or incorrect fabric care instructions which
have been provided with the garment or article.
Start the drying programme by pressing the “Start (Pause)” button.
The relevant indicator lamp lights up.
Changing programme selection: if the selected programme is changed during
drying, the dryer stops. The “Start (Pause)” indicator lamp flashes.
To run the new programme, press the “Start (Pause)” button again.
Interrupting programme: to interrupt a drying cycle, press the “Start (Pause)”
button and open the door. Wait at least 5 minutes, to allow the laundry to cool down,
before unloading the dryer. For your safety, the drying cycle stops automatically if you
open the door. To restart the cycle after opening the door, press the “Start (Pause)”
button again.
Warning: never stop a tumble dryer before the end of the drying cycle, unless all
items are quickly removed and spread out so that the heat is dissipated.
The final part of a drying cycle occurs without heat (cool-down cycle) to ensure that
the items reach a lower temperature to avoid wrinkling.
End: take the laundry out of the dryer. The drying process is complete and the anticrease phase has been reached (active).
Set the programme selector knob to “Off” (“O”).
1
Page 2
2
Cotton
Easy care
Special
programmes
Airing
Drying
times
Approximate
Overview of programmes Options
drying times
(in minutes)
Programmes / Drying levels
Extra dry
Cupboard dry +
Cupboard dry **
Iron dry **
Cupboard dry +
Cupboard dry **
Iron dry
Mixed load
Ty p e of t ex ti le
Multi-layered, thick laundry such as: terry towels, terry
towelling bath robes.
Terry towels, dry towels, bed linen, underwear.
Similar types of laundry which do not require ironing such as:
dry towels, bed linen, underwear, baby clothes, T-shirts,
cotton socks.
Laundry which requires ironing such as: bed and table linen,
dry towels, T-shirts, polo shirts, work clothes.
Laundry with thick, multi-layered areas such as: bed and table
linen, track suits, anoraks, blankets.
Laundry which does not require ironing such as: shirts,
blouses, T-shirts, sportswear.
Laundry which requires ironing such as: trousers, dresses,
skirts, shirts, blouses.
T-shirts, blouses, towels, underwear, sportswear.
Fabrics
Cotton or linen hot wash/
coloured laundry
Max. 7 kg
Synthetic, mixed fibre or cotton easy care
(ironing not required) laundry
Max. 3.5 kg
Cotton - Synthetic blend
Max. 3 kg
Volume
of load
kg*
3.0
7.0
3.0
7.0
3.0
7.0
3.0
7.0
1.0
3.5
1.0
3.5
1.0
3.5
Gentle
Délicat
X X
X X
X X
X X
X X
X X
X X
Anti-
crease+
Anti-
froissage+
Ver y
wet
load
75’
160’
70’
140’
65’
115’
50’
100’
35’
80’
25’
55’
20’
45’
3.0 X X 80’ 60’
Wet
load
65’
140’
60’
120’
55’
100’
40’
85’
25’
60’
20’
40’
15’
35’
Laundry is aired, refreshed and loosen up
for 30 minutes without heating.
20’ 30’ 40’ 60’ 90’
* Weight of average and maximum load.
** Test programmes according to EN 61121, tested with maximum rated load capacity.
All textiles.
Additional drying time for textiles that are not suitable for
other programmes, or for finalisation of the drying process.
All fabrics
— — — — —
— X X
20’ 30’
40’ 60’ 90’
Page 3
How to proceed if...
...you want to check the dryer yourself first: (If your machine is not functioning correctly, please
check the following points before calling the Customer Service department - also refer to relevant
section in the Instructions For Use).
• Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)?
• Is the lint filter dirty? (filter indicator light on)
• Is the heat exchanger dirty? (for more information, refer to the Instructions For Use)
• Is the room temperature too high?
Drying takes too long/
Laundry is not dry enough
The dryer does not
operate (after a power
failure, always press the
“Start (Pause)” button)
• Are the “End” and “Anti-crease” indicator lamps lighting up? The drying cycle is
complete and the laundry can be taken out.
• If the drying result does not meet your expectation, select a drier programme or use
the dryness adjustment option (if available).
• Are thin and thick laundry mixed? Are different types of materials mixed? Sort the
laundry by thickness and material, then dry it again.
• Is the plug properly inserted into the mains electricity socket?
• Is there a power failure?
•Has the fuse blown?
• Is the door properly closed?
• Has a drying programme been selected?
•Has the “Start (Pause)” button been pressed?
• Has the start delay option been selected?
• Is the dryer overloaded? Please remove some of the load.
Lint filter, water container
or heat exchanger
indicator lamp on
Water droplets
underneath the dryer
• Is the lint filter clean?
• Is the water container empty?
• Has the water container been inserted correctly?
• Is the heat exchanger clean and inserted correctly?
• Has the heat exchanger been inserted correctly?
• Has all lint on the heat exchanger seal and the door seal been wiped away?
• Has the water container been inserted correctly?
• If the direct drain connection is used, is it tight?
• Is the dryer levelled?
...you want to care for and clean your dryer:
Clean the filter at the end
of every cycle
Empty the water container
at the end of every drying
cycle
Clean the heat exchanger
at least once a month
• Brush lint using a soft brush or your fingertips.
• Close the filter.
• Push the filter back into place.
• Pull the handle to remove the water container.
• Empty the water container.
• Replace the empty water container by pushing it fully back into place.
• Clean the heat exchanger under running water.
• Remove all lint from the seals.
• Clean the heat exchanger housing (for further information see section “Cleaning the
heat exchanger” in the Instructions for Use).
3
Page 4
Failure codes
In the event that the dryer malfunctions, one of the following failure codes may be displayed.
Depending on the model of your dryer, the failure may be displayed in letters or by different
blinking LEDs.
Failure code LED failure code Check to be carried out by customer before service call
F01
F02
F03
F04
F05
F06
Please call the After-Sales Service.
Please call the After-Sales Service.
Please call the After-Sales Service.
Please call the After-Sales Service.
Turn the dryer OFF and unplug it. Make sure that the ambient temperature is
between 5°C and 35°C. Wait for 1 hour. Plug the dryer back in and restart it. If the
Turn the dryer OFF and unplug it. Make sure that the ambient temperature is
between 5°C and 35°C. Wait for 1 hour. Plug the dryer back in and restart it. If the
failure reoccurs, please call the After-Sales Service.
failure reoccurs, please call the After-Sales Service.
F07
Start LED blinks
2 times per
second when
pressed
4
Please call the After-Sales Service.
Make sure that the door is correctly closed and the heat exchanger correctly positioned.
If the failure reoccurs, please call the After-Sales Service.
LED not blinking LED blinking
Page 5
Before using the machine, please also read the Instructions For Use carefully!
GB
AZB 7470
Quick Reference Guide
Programme selector knob
The drying programme is selected by
turning this knob. The “Start (Pause)”
indicator lamp flashes.
“Start (Pause)” button
The drying programme is started by
pressing this button. The indicator lamp
lights up.
Clean filter
The indicator lamp lights up when the
filter and/or the heat exchanger and its
housing need to be cleaned.
Clean the filter at the end of every
drying cycle.
Water container
Indicator lamps
Overdry protection / 6th Sense
The indicator lights up when a humidity
controlled programme is selected, to
indicate the activated protection function.
Gentle
Selecting this option will reduce the drying
temperature. This option cannot be selected
when the “Rapid” option is selected.
Anticrease+
This option can be chosen to reduce
wrinkling, when the laundry is not unloaded
immediately after the end of the cycle. The
drum turns from time to time for up to 12
hours. It can be interrupted at any time by
switching off the dryer. This option deactivates
The indicator lamp lights up when the
water container needs to be emptied.
The drying cycle is automatically
interrupted. Empty the container and
restart the drying programme.
Empty the water container after
every drying cycle.
End of cycle
The drying programme is finished. Please
unload the dryer.
the “Buzzer” function, if it is activated.
5019 307 01542
(Subject to technical modifications)
5
Loading...