Whirlpool AWZ QUALITY, AWZ 850, AWZ 851, AWZ EXPERT CI, AWZ 867 User manual

CONTENTS
BEFORE USING THE DRYER/CONNECTIONS
PRECAUTIONS AND GENERAL RECOMMENDATIONS
DESCRIPTION OF THE DRYER
DRAINAGE SYSTEM ONLY FOR WATER CONTAINER TOP VERSION
DOOR REVERSIBILITY
HEAT EXCHANGER
10
BEFORE USING THE DRYER/CONNECTIONS
1. Removing the packaging and check 
After unpacking, make sure that the dryer is undamaged. If in doubt, do not use the dryer. Contact After-Sales Service or your local retailer.
Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.
Remove the protective foil from the control panel.
2. Electrical Connections 
Electrical connections must be carried out by a qualified technician in compliance with the manufacturer's instructions and current standard safety regulations.
Electrical connection must comply with local Electricity Board regulations.
Voltage information, power consumption and the required fuse protection is shown on the rating plate mounted at the rear of the dryer.
The manufacturer cannot accept any liability for personal injury or damage to property resulting from failure to adhere to these instructions.
The dryer must be earthed as prescribed by law.
Do not use extension leads or multiple adaptors.
Before any maintenance on the dryer disconnect it from the mains supply.
Do not operate the dryer if it has been damaged during transport. Contact one of our After-Sales Service technicians.
Mains cable replacement is only to be carried out by After-Sales Service.
Stability:
When installing the dryer always carefully level the dryer adjusting the four feet and check the correct levelling with a spirit level.
Stacking kit
Your dryer can be stacked on top of your front loading washing machine. To do this, use stacking kit AMH 542, available from your dealer.
Minimum housing dimensions:
Width: 600 mm Height: 850 mm Depth: 600 mm
3. Installation
Do not install your drye r w he re it ca n be subject to extreme conditions, such as: poor ventilation, temperatures around freezing or above 35° C.
Before running the first cycle ensure the water container and heat exchanger are correctly positioned.
Only for water container top version: if possible use the hose supplied to drain the water directly into the domestic plumbing system. This will avoid having to empty the water container at the end of each drying cycle since the condensation water can be directly drained away.
Take care not to trap the mains cable between the dryer and the wall.
11
Loading...
+ 4 hidden pages