Whirlpool AWZ 9995 INSTRUCTION FOR USE
Before using the machine, please also read the instructions for use carefully!
AWZ 9995
Programme selector knob
The drying programme is selected by turning
this knob.
Start/Pause button
The drying programme is started by pressing
this button. The indicator lamp flashes during
the selection phase and lights up during
drying.
Indicator lamps
Filter
The indicator lamp lights up when the filter
and/or heat exchanger need cleaning.
Clean the filter at the end of every cycle.
Water container
The indicator lamp lights up when the water
container needs to be emptied. The drying
cycle is automatically interrupted. Empty the
container and restart the drying programme.
Empty the water container after every
drying cycle.
Remaining time display
Depending on the programme selected, once
the drying cycle has been started, a default
drying time is displayed. The time displayed is
corrected by a few minutes depending on the
volume, type and dampness of the laundry.
The drying time specified is a calculated
value which will be updated during the
drying programme.
The flashing lines indicate that the calculation is
running. The remaining time will be updated.
Overdry protection
The indicator lamp lights up when a humidity
controlled programme is selected, to indicate
the working protection function. Function is
not active in time controlled programmes
40’ 60’ and Airing.
Quick Reference Guide
Programme sequence
20’
th
6
Sense
Options
Drying
Gentle
Reduces drying intensity
(recommended for delicate items).
Rapid Cotton
Shortens drying duration (recommended for
thin items of the same size).
Buzzer
Signals/sounds end of drying cycle.
Anti-crease
Prevents laundry from creasing up to 12
hours. Buzzer and Anti-crease cannot be
selected together.
Start Delay
Delays the start of the drying cycle by 1 to 12
hours.
Each time the button is pressed, the start
time is delayed by 1 hour.
Then press the Start/Pause button to confirm
the final selection and to start the dryer.
The delayed start indicator lamp flashes and
the countdown counts down in 1-hour
intervals. The countdown is indicated by the
indicator lamp above the button flashing.
During the countdown, the drum will turn
from time to time to re-distribute the
laundry. To cancel or change the previously
set time delay, set the programme selector
knob to or open the door.
End
of cycle
GB
+
Anti-
crease
Whirlpool is a registered trademark of Whirlpool USA
5019 307 00490
(Subject to technical modifications)
4
Machine operation
Additional information (including troubleshooting and service) can be found in the individual chapters of the
instructions for use.
Sort laundry according to
care symbols:
Do not tumble dry
Suitable for tumble drying at low drying temperature
Suitable for tumble drying
Sort by:
Material thickness: Whenever there is greater load than the dryer can handle,
separate laundry according to weight (e.g. dry towels and thin underwear
separately).
Type of material: Cotton (linen); synthetic textiles (easy care).
Degree of drying: Cupboard dry, iron dry etc.
Do not tumble dry: Woollens, silk, nylon stockings, delicate embroidery, fabrics
with metallic decorations, bulky items such as sleeping bags, etc.
Preparing laundry
Opening door
Loading dryer and
closing door
Switching on machine and
selecting programme
Selecting options
(if available)
Starting dryer
Check that all fastenings are closed and that pockets are empty. Please ensure that
there are no cigarette lighters in the wash. Turn laundry inside out.
Pull the door handle. If the child safety lock is activated, please deactivate it
(additional information can be found in the “Door Reversibility/Child Safety Lock”
chapter of the instructions for use).
Place laundry loosely in the drum to achieve equal drying throughout. Then close
the door.
Select the drying programme required by turning the programme selector knob
(for information, refer to programme table).
Select the option required by pressing the corresponding button.
The indicator lamp above the relevant button lights up to confirm your selection. An
alarm sounds if an incorrect selection is made (incompatible options). Press the
button again to cancel the option.
The drying programme is started by pressing the Start/Pause button.
The relevant indicator lamp lights up.
Changing programme selection: If the programme selected is changed during
drying, the dryer stops. The Start/Pause indicator lamp flashes. To operate the new
programme, again press the Start/Pause button.
Interrupting programme: To interrupt the dryer during the drying cycle, set the
programme selector knob to “Airing” and press the Start/Pause button. Wait at
least 5 minutes before opening the door to allow the dryer to cool down. For your
safety the drying cycle stops automatically if you open the door. To restart, after
door opening, close the door and press the Start/Pause button again.
End: Take the laundry out of the dryer. The drying process is complete
and the anti-crease phase has been reached (active).
Programme end -
unloading dryer
Set the programme selector knob to .
Cleaning the lint filter: Open door, pull lint filter up and out of machine and open
it. Brush lint using a soft brush or your fingertips. Close lint filter and push firmly
Switching dryer off
Please note: Only use additives/plastic items specified as dryer safe and rinse items that have been treated with stain remover
thoroughly in plenty of water before drying. Never dry rubber objects or objects stained with vegetable oils in the dryer.
back into place.
Emptying water container: Pull container out by the handle and empty. Replace
the container when empty by pushing it completely back into place.
If required, activate child safety lock (additional information can be found in the “Door
Reversibility/Child Safety Lock” chapter of the instructions for use).
Anti Crease: If the laundry is not removed at the end of the drying
cycle, an automatic anti-crease cycle will operate for maximum 60
min. The drum rotates at regular intervals to prevent the laundry
from creasing.
1
Loading...