Whirlpool AWZ 663 INSTRUCTION FOR USE
CONTENTS
BEFORE USING THE DRYER/CONNECTIONS
PRECAUTIONS AND GENERAL RECOMMENDATIONS
DESCRIPTION OF THE DRYER
DRAINAGE SYSTEM ONLY FOR WATER CONTAINER TOP
VERSION
DOOR REVERSIBILITY
CHILD SAFETY LOCK
HEAT EXCHANGER
10
BEFORE USING THE DRYER/CONNECTIONS
1. Removing the packaging and check
After unpacking, make sure that the dryer is
undamaged. If in doubt, do not use the dryer.
Contact After-Sales Service or your local retailer.
Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children, as
they are potentially dangerous.
Remove the protective foil from the control panel.
2. Electrical Connections
Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer's instructions and current standard
safety regulations.
Electrical connection must comply with local
Electricity Board regulations.
Voltage information, power consumption and the
required fuse protection is shown on the rating
plate mounted at the rear of the dryer.
The manufacturer cannot accept any liability for
personal injury or damage to property resulting
from failure to adhere to these instructions.
The dryer must be earthed as prescribed by law.
Do not use extension leads or multiple adaptors.
Before any maintenance on the dryer disconnect it
from the mains supply.
Do not operate the dryer if it has been damaged
during transport. Contact one of our After-Sales
Service technicians.
Mains cable replacement is only to be carried out
by After-Sales Service.
Stability:
When installing the dryer always carefully level
the dryer adjusting the four feet and check the
correct levelling with a spirit level.
Stacking kit
Your dryer can be stacked on top of your front
loading washing machine. To do this, use stacking
kit AMH 542, available from your dealer.
Minimum housing dimensions:
Width: 600 mm
Height: 850 mm
Depth: 600 mm
3. Installation
Do not install your drye r w he re it ca n be subject to
extreme conditions, such as: poor ventilation,
temperatures around freezing or above 35° C.
Before running the first cycle ensure the water
container and heat exchanger are correctly
positioned.
Only for water container top version: if possible
use the hose supplied to drain the water directly
into the domestic plumbing system. This will avoid
having to empty the water container at the end of
each drying cycle since the condensation water can
be directly drained away.
Take care not to trap the mains cable between the
dryer and the wall.
11
Loading...