Whirlpool AKF 616 IX, AKF 619 IX, AKF 615 IX, AKF 618 IX INSTRUCTION FOR USE

AKF 618 / AKF 619 PRODUCT DESCRIPTION SHEET

IT

1. Removable grids

2-5. Medium burners

3. Large burner

4. Auxiliary burner

6. Triple crown burner

7. Front left burner control knob

8. Rear left burner control knob

9. Central burner control knob

10. Rear right burner control knob

11. Front right burner control knob

Symbols

	Shaded	Tap closed
	circle
	Large flame	Maximumopening/delivery
	and star	and electric ignition
	Small flame	Minimum opening or
		reduced delivery

Operation of burners with safety device and electric ignition

To light one o the burners:

•Press the relative knob and turn it anti-

clockwise to the large flame and star setting .

•At the same time, hold the knob down until the burner ignites.

•After the burner has ignited, keep the knob pressed for about 10 seconds.

•Release the knob.

If the burner does not ignite, repeat the operation.

Note:

—Should particular local conditions of the delivered gas make ignition of the burner difficult, it is advisable to repeat the operation

with the knob turned to the small flame setting .

—The burner safety device shuts off the gas supply to the burner if the flame goes out accidentally (because of a sudden draught, an interruption in the gas delivery, boiling over of liquids, etc.).

—The separator panel, positioned beneath the cooktop at a minimum distance of 20 mm, must be sealed.

Insert a wooden panel at least 20 mm thick under the hob, at a distance of at least 15 mm from the cooking hob bottom.

5019 519 66008

DIMENSIONS OF COOKING HOB AND WORKTOP (mm)

NOTES: If the distance “A” between the wall cabinets is between 600 mm and 680 mm, the height “B” must be at least 520 mm.

If the distance “A” between the wall cabinets is greater than the width of the hob, the height “B” must be a minimum of 400 mm.

Before installing a hood above the hob please refer to the hood instructions, which specify the correct distance.

INJECTORS TABLE											CATEGORY II2H3+
Type of gas used		Type of		Injector		Rated heat	Rated			Reduced			Gas pressure mbar
		burner		marking		capacity	consumption			heat
				100/mm		kW				capacity		min.		rat.		max.
										kW
NATURAL GAS		triple crown		141		3.50		333 l/h		1.50
		rapid		129		3.00		286 l/h		0.80		17		20		25
(Methane)	G20	semi-rapid		101		1.75		167 l/h		0.50
		auxiliary		77		1.00		95 l/h		0.50
LIQUID		triple crown		94		3.50		254 g/h		1.50
		rapid		87		3.00		218 g/h		0.80
PETROLEUM GAS												20		28-30		35
		semi-rapid		66		1.75		127 g/h		0.50
(Cylinder)	G30
		auxiliary		50		1.00		73 g/h		0.50
LIQUID		triple crown		94		3.50		254 g/h		1.50
		rapid		87		3.00		218 g/h		0.80
PETROLEUM GAS												25		37		45
		semi-rapid		66		1.75		127 g/h		0.50
(Cylinder)	G31
		auxiliary		50		1.00		73 g/h		0.50
Type of gas			Appliance model		Total rated heat				Total rated				Air necessary (m3)
used					capacity				consumption				for the combustion
					kW								of 1 m3 of gas
G20 20 mbar			5 gas		11				1048				22
G30 28-30 mbar			5 gas		11				799				22
G31 37 mbar			5 gas		11				799				22

ELECTRIC SUPPLY: 230 V ~ 50 Hz