Whirlpool ADG 9968/1 M INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

ADG 9968

Indicators

Quick Reference Guide

On button

Off button

Programme selection button

Start button

Switches “on” when the dishwasher is operating.
Flashes when a fault occurs. Switches o ff at th e end
of the programme.

Add rinse aid

Add regeneration salt

Only add regeneration salt immediately before
starting a wash programme.

Options

GB

Time and failure display

Indicates in hours the time remaining
until the start of the wash cycle . Switches
off when the programme has started.
Toward the end of the programme, during
the drying cycle, the display will indicate
the time remaining in minutes.

“F....” Identification of faults for

service technician

“Delayed start” buttons

The wash cycle can be programmed to
start after 1 - 24 hours. With each
successive touch of the button, the
delayed start indicator increases by 1
hour, and after 24 returns to 00. Then
press the Start button. The dishwasher
will start at the set time.

“Half load” button

This function can be used with any
programme. The indicator lamp switches
on. The wash cycle is activated for the

or

upper

lower rack
When washing without the top r ack, press
the “Half Load” button (LED alight).

only

3)

.

Programme chart

Detergent

2)

Consumption

Programmes Loading instructions A B Litres kWh Minutes

Sensor Normal

Sensor Intensive

40-55°C

60-70°C

Pre-Rinse cold

Glass 40°C

Quickwash 40°C

Eco-Normal

Antibacterial

1) Reference programme for energy label in compliance with
EN 50242 regulations;

2) Refer to “User instructions“;

3) Program data obtained in conformity with European standard EN

50242. Values may vary in r elation to usage, e .g.: different loads,
water temperatures - above or below 15°C - as well as water
hardness and power supply voltage, etc.

Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: “[e-mail]”.

Whirlpool is a registered trademark of Whirlpool USA

1)

4) 5)

Automatic progr amme r ecomm end ed f or
routine washes, with no d ri ed-on or burnt
food (not for EN 50242).

Automatic progr amme r ecomm end ed f or
heavily soiled crockery with dried-on or
burnt food, for example pan s and s au cepans .

Crockery to be washed later. - - 4.0 0.03 14

Light soiling, for example glasses and
cups.

Lightly soiled crockery, with no dried-on
food.

Normally soiled crockery. X X 13.0 1.05 135

50°C

Normally or heavily soiled crockery,
with additional antibacterial action.

4) The bacteria removal efficiency has been tested by the Institut
Pasteur de Lille ( France), based on the NF EN 13697 standard of
November 2001.

5) Programme interruption (e.g. the door being opened) may
compromise the result of the antibacterial rinse.

X X 10.0-13.0 0.80-1.05 60-120

X X 13.0-20.0 1.10-2.00 100-150

X - 10.0 0.80 55

X - 10.0 0.65 30

X X 13.0 1.50 115

5019 396 91480

(We reserve the right to make technical modifications)

3)

WH/I/FD/GB

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Open the door,

switch on the appliance

How to fill the

detergent dispenser

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Select a programme

Select options

Press the ON button.

Large compartment A:
With each wash cycle.
Small compartment B:
For programmes with pre-wash only.

Mechanical indicator C.
Electric indicator on control panel (if provided).

On models with water softener system only .

Mechanical indi cator D. Electri c indi cator
on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Press the button until the desired programme lights up.

If necessary (and if provided)
the corresponding indicator lamp lights up.

ABC

Press the Start button

Turn on the water tap

close the dishwasher door

Wa sh cycle

Switch off the appliance

Turn off the water tap,

unload the racks

The selected progr amme is then
memorised (even in th e event
of power fai lur e).

At the end of the progr amme an acoustic sign al will sound.
Only after the ST ART button has switched o ff: press th e OFF button.
All the indi cator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change progra mme”

Press the START button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and press

the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched o ff d urin g a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.

WH/II/FD/GB