Before using the Tomato Press for the rst time,
and after every use, the unit must be completely
disassembled and cleaned with hot, soapy water. Rinse
with clear. Dry immediately. The Tomato Press is top-
rack dishwasher safe.
For hard to reach areas, we recommend using a soft
bristle brush.
For cleaning the Screen, it is highly recommended to
wear heavy, sturdy gloves, such as Kevlar Cut Resistant
Gloves; failure to do so may cause personal injury.
CLEANING INSTRUCTIONS
To disassemble the Tomato Press, please follow the simple steps listed below:
1. Remove the Juice Chute by gently pulling it straight out from the Base.
2. Remove the Handle, by turning it counter-clockwise until it un-threads from the
Roller Assembly.
3. Reach into the Hopper to remove the
Roller Assembly. NOTE: DO NOT reach
into the Hopper UNLESS the Handle has
been REMOVED! Failure to follow this
warning may cause severe injury!
4. While holding the Roller Assembly,
pinch the Roller Fins and slide them out of
the channel. This will also release the Cap,
allowing the Roller Fins and Spring to be
removed from the housing.
5. Disassemble the Roller Fins and Spring.
6. The Tomato Press is now completely disassembled and ready to be cleaned.
DISASSEMBLY INSTRUCTIONS
To assemble the Tomato Press, please follow these simple steps:
1. Dampen the rubber Suction Cup on the Base and press it onto a smooth,
level working surface. NOTE: When positioning, make sure the Suction Cup
Locking Arm is in the raised position.
2. Hold the Base and push the Suction Cup Locking Arm to the down position.
3. Install the Roller Assembly into the Base. Make sure the threaded portion
lines up with the Handle Hole.
4. Insert the Handle, with the O-Ring installed onto the shaft, into the Handle
Hole and turn the Handle clockwise to secure it to the Roller Assembly.
5. Attach the Juice Chute to the Body by positioning the tab on the Juice Chute
into the notch in the Body under the Screen.
6. Once assembly is complete, try to move Tomato Press. If there is any
movement, repeat steps 1 and 2.
7. Tomato Press is now ready for use.
ASSEMBLY INSTRUCTIONS
WARNING!
Protective/cut-resistant
Kevlar Gloves are
recommended
whenever handling the
Screen assembly!
-4- -5-
Spring
Roller Fin
Cap
Roller Assembly
RECIPES
ITALIAN TOMATO SAUCE___________________________________________
2 lb plum tomatoes 1/2 cup extra-virgin olive oil 1/4 cu p chopped whi te onions
1/4 cup nely chopped celery 1 tsp sugar 1 Tbsp ne sea salt
• Core and quarter the tomatoes, then run them through Tomato Press to yield fresh tomato puree.
• Heat the olive oil over a medium heat in a large pan.
• Add the onions and celery and sauté until tender, do not overly brown.
• Add the rest of the ingredients.
• Bring mixture to a boil, reduce heat and simmer.
• Stir occasionally.
• Simmer until sauce has thickened, 15 to 20 minutes.
QUICK APPLESAUCE________________________________________________
3 Tbsp butter 6 Macintosh apples 1/4 cup sugar
1 tsp cinnamon 1/2 tsp nutmeg 4 Tbsp water
• Steam apples in a covered pot for approximately 15 minutes or until soft.
• Allow apples to cool.
• Core and quarter the apples then run them through Tomato Press
• Mix the remainder of the ingredients with the apple puree and chill.
NOTE: The Tomato Press works great with soft fruits and vegetables. Firm or hard
fruits and vegetable will need to be cooked to soften prior to straining.