Westinghouse NT14L123P-CS Instruction Manual

1 / 7

INSTRUCTION MANUAL

STEAM IRON

NT14L123P-CS

Please read these instructions before using the appliance

2 / 7

Main features and structure:

The product has many functions such as temperature regulating, Spraying, Dry Ironing, Steam, Strong steam,
Self-Cleaning Function etc. and is with characteristics: luxury shape, high heat efficiency, easy using, good
ironing result, work saving and time saving, and so on.

A: Burst steam button
B: Spraying button
C: Steam regulating Knob
D: Self-clean button
E: 360 degree swivel cord
F: Cover of water filler

G: Spraying mouth
H: Temperature adjusting knob Water tank

I:Water Tank

J: Soleplate
K: Indicate light

Read all instructions before using the iron

For house hold use only

1. Use the iron for its intended purpose, for ironing fabrics on board.

2. To protect against burns or injury to persons, do not iron or steam fabrics while being worn on the body.

3. The iron should always be turned ‘OFF’ before plugging or unplugging from outlet. Never pull cord to

disconnect from outlet, instead, grasp plug and pull to disconnect.

4. Do not allow cord to touch hot surface. Allow the iron to cool completely before storing.

3 / 7

5. Always disconnect iron from electrical outlet for filling or emptying water and when not in use.

6. To avoid risk of electric shock, do not operate iron with a damaged cord or if the iron has been dropped

or damaged. For repair, take it to an authorized Westinghouse Service center.

7. Close supervision is necessary for this appliance being used by or near children. Do not leave iron

unattended while connected or on an ironing board.

8. Burns can occur from touching hot metal parts, hot water, or steam. Hot water may leak from the iron.

Use caution when filling or turning the steam iron upside down.

9. To protect against burns or injury to persons, do not direct steam toward the body when ironing.

10. The iron must be used and rested on a stable surface. When placing the iron on its stand, ensure that the

surface on which the stand is placed is stable.

How to fill with water:

Make sure the iron is turned off and the power cord is unplugged from the electrical outlet.

1. Set the ‘Variable’ steam knob to the ‘ ”’ position before filling the iron with water.

2. Open the ‘Water Fill’ Opening and fill the Tank up to the ‘MAX’ Line on the tank.

3. The water level can be observed through the transparent part of the tank, when iron placed vertically, in

case of water level becomes low, refill the tank, following the procedure described in steps 1 to 3 above.

4. Pour out the remaining water after use.

Note:

Most tap water can be used in this iron. Do not use water additives or substitute water such as linen or
scented water in the steam iron, they can stain fabrics or damage the iron. Do not fill the water more than
the ‘MAX’ position.

How to use as dry iron:

1. Position the iron vertically.

2. Plug the iron.

3. Set Steam regulating Knob to MIN position.

4. Preheat the iron until the indicator light goes out.
Now dry ironing can begin.

How to use the spray:

Before using the spray feature, check the fabric label for ironing instructions because some fabrics may be
spotted or stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and where extra dampening is
needed. The spray may be use with steam or dry ironing. Simply pump the Spray Mist knob when spray is
desired.