Westinghouse ACC290 Installation Guide

Installation manual

Left Hand

Slide Runners

Fitting Slide Runners

Obtain left hand side rack and left hand slide –

1

see image to identify.

L = left hand side
R = right hand side

Fit slide rear clips to the rear of wire at an angle

2

as shown.

1

Push slide front clip over wire until secure.

3

Using Slide Runners

NOTE: For 60cm ovens, ONLY use the wire shelves
provided in the accessory pack. These are designed
specifically for use with slide runners. Original wire
shelves may continue to be used in positions without
runners as normal or discarded.

To fit a shelf or tray to slide runners:

• With the slides fully pushed in, push the shelf or tray along
the top of the slide until it hits the back post.

• Drop the front of the shelf or tray onto the slide ensuring
it sits behind the front post of the slide.

• When fully inserted the shelf/tray should not interfere
with the closed oven door.

Back post

2

3

CLICK!

Slide Runners may be fitted onto any of the side rack wire
positions as highlighted.

Side racks

• The side racks attach to each side of your oven

• There is a left hand and right hand version

• Insert the rear peg into the rear access hole provided, ensuring
that the peg is fully inserted

• Then locate the front peg into the front access hole and push in firmly

Left hand liner (shiny side touches
the oven wall)

Front Peg

front peg

Left hand side rack

rear peg

Side Rack

Front post

Rear Peg

and WESTINGHOUSE are trademarks of Westinghouse Electric Corporation. Used under license by Electrolux Home Products Pty Ltd. All Rights Reserved. © 2019 Electrolux Home Products Pty Ltd. WINS_SlideRunners_Mar19