600-900 Canopy Installation and Operation Manual
The instructions in this manual are for cooker hood models: CS601, CS901, WRF600, WRF900,WRG950CGS
These cooker hoods are domestic appliances which have been manufactured and tested to comply with Australian and New Zealand Standard AS/NZS 3350.2.31.
Safety Warnings
Young children should be supervised to ensure they do not play with the cooker hood.
The cooker hood is not intended for use by young children or infirm persons without supervision.
Ensure the cooker hood is switched off before carrying out maintenance, to avoid any possibility of electric shock.
Grease filters must be removed every four weeks (maximum) for cleaning to reduce the risk of fire.
Do not flamb’e under the cooker hood.
This cooker hood is not recommended for barbeques.
The exhaust air from the cooker hood must not be discharged into any heating flue, which may carry combustion products from other sources.
Exhaust air must not be discharged into a wall cavity, unless the cavity is designed for the purpose.
There must be adequate ventilation of the room when the cooker hood is used at the same time as appliances burning gas or other fuels.
Always cover lit gas burners with pots or pans when the cooker hood is in use.
Always switch off gas burners before you remove pots or pans.
Cleaning
Wipe the cooker hood body and flue with a sponge or soft cloth soaked in warm soapy water. Do not use oven cleaners or other abrasive materials.
Electrical Connection
Check that the mains voltage matches with the voltage on the data plate inside the cooker hood.
Check that the installation complies with standards of local gas and electricity authorities.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
Accessories
Use 125mm round exhaust ducting for best performance.
When using flexible duct always install duct with the wire helix pulled taut to minimise pressure loss.
Try to keep exhaust duct short and straight.
Keep bends in the exhaust duct to a minimum. |
INSTALLATION OPTIONS |
|
Do not reduce the size or restrict exhaust duct. |
|
|
DUCTING ACCESSORIES |
|
|
|
Roof cowl |
|
|
AR125RC |
|
Flue |
Top Exhaust |
|
1200mm length |
||
AR125F |
to atmosphere |
|
|
Flashing |
|
|
Not Supplied |
Rear Exhaust |
|
|
|
|
|
to atmosphere |
Wall vent |
AR500FS |
|
(includes |
400mm of flue) |
|
AR125WV |
|
|
|
90º bend |
Recirculating |
|
AR125B |
|
|
Installation |
|
|
|
|
AR125FD
Alternative flue connection
1 metre flexible duct with joiners
Side Exhaust to atmosphere
AR500RK
Part Numbers: |
Description: |
AR125RC |
Roof Cowl |
AR125B |
90º Bend |
AR125F |
Flue 1200mm Long |
AR125FD |
Flexible Duct - 1 Metre Long When Expanded |
AR125VW |
Wall Vent Kit |
AR500FS |
Extra Length Flue Cover 1100mm Length Brushed Stainless Steel |
AR500RK |
Recirculating Kit |
AR500CF |
Replacement Carbon Filters |
1
2
3
4
5
6
Loading...