2011 West Bend®, a Brand of Focus Electrics, LLC.
www.westbend.com
IMPORTANT SAFEGUARDS
To prevent personal injury or property damage, read and follow all instructions
and warnings.
When using electrical appliances, basic safety precautions should always be
followed including:
• Read all instructions.
• To protect against fire, electric shock, and injury to persons do not immerse
cord, plugs, or other electric parts in water or other liquids.
• Close supervision is necessary when this appliance is used by or near children.
• Always unplug from outlet when not in use and before cleaning. Allow to cool
before putting on or taking off parts and before cleaning.
•Do not operate any appliance with a damaged cord or plug, after the appliance
malfunctions, or has been damaged in any manner. For service information see
warranty page.
•The use of accessory attachments not recommended by Focus Electrics may
cause fire, electric shock, or injury.
• Do not use this appliance outdoors.
• Do not let cord hang over the edge of the table or counter, or touch hot surfaces.
• Do not place on or near a hot gas or electric burner, or in a heated oven.
• To disconnect, turn any control to “OFF,” then remove plug from wall outlet.
• Do not use appliance for other than intended use.
• Extreme caution must be used when moving an appliance containing hot oil or
other hot liquids.
• Do not attempt to repair this appliance yourself.
• A short power-supply cord is provided to reduce risks resulting from becoming
entangled in or tripping over a longer cord.
•Longer extension cords are available, but care must be exercised in their use.
While use of an extension cord is not recommended, if you must use one,
ensure that the marked electrical rating of the extension cord is equal to or
greater than that of the appliance. If the plug is of the grounded type, the
extension cord must be a grounding-type 3-wire cord. To avoid pulling, tripping
or entanglement, position the extension cord so that it does not hang over the
edge of the counter, table or other area where it can be pulled on by children or
tripped over.
•This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit into a polarized outlet
only one way. If the plug does not fit fully into the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician. Do not attempt to modify the plug
in any way.
•Do not use an outlet or extension cord if the plug fits loosely or if the outlet or
extension cord feels hot.
• Avoid contact with moving parts.
• Keep hands, hair, clothing, as well as spatulas and other utensils out of the
container to prevent personal injury or damage to the mixer.
2
• Never add ingredients to the container while the appliance is operating.
• Container must be properly in place before operating the appliance.
• For household use only.
SAVE THESE INSTRUCTIONS
Control Switch
Cup Support
Mixing Head
Cup Rest
Mixing Wand
Blending Cup
“MAX” Fill Line
B
EFORE USING FOR THE FIRST TIME
Please check all packaging material carefully before discarding. Many
accessory parts are contained within the packaging material.
See “Cleaning your Milk Shake Maker” section of this manual.
U
SING YOUR MILK SHAKE MAKER
1. Tilt the mixing head back and insert the mixing wand. The wand is properly
inserted when you feel it “snap” into place. You may have to turn the wand to fit
the wand completely into the mixing head. Return the mixing head to the upright
position.
2. Set the control switch to “ O ” and plug the cord into a 120 volt, AC outlet ONLY.
3. Place ingredients to be mixed into the blending cup. Ensure that the ingredients
do not exceed the “MAX” (14oz./ 414mL) indicator line.
4. For hands-free mixing, attach the blending cup on to the Milk Shake Maker. The
cup should be completely under the cup support and sitting on the cup rest.
3
5. Begin mixing at low speed, “ l ”. If desired, high
speed “ ll ” can be used for the final stage of
mixing.
6. While mixing, the cup can be removed from the
support and moved around to achieve more
thorough blending. You may find it easier to tilt
and hold the mixing head while blending. Make
sure the mixing wand is always immersed while
in use.
7. When mixing is complete, set the control switch to “ O ”. Remove the mixing cup
and pour the mixture into desired serving container.
•A small amount of smoke and/or odor may occur upon use due to the
release of manufacturing oils – this is normal.
•Some minor expansion/contraction sounds may occur during use – this is
normal.
H
ELPFUL HINTS
The Milk Shake Maker can also be used to mix thin batters and eggs.
Do not use whole fruits when mixing. Mashed or pureed fruits work best in the Milk
Shake Maker.
Always add any syrups or powders last to prevent them sinking to the bottom of the
blending cup.
For best results, ensure that all ingredients are as cold as possible before mixing.
Drinks made with ice cold milk will mix thicker and frothier than if warmer milk is
used.
This appliance cannot crush ice. If you wish to make a drink with ice, use ice that has
already been crushed.
C
LEANING YOUR MILK SHAKE MAKER
1. With the control switch set to “ O ”, unplug the appliance from the outlet.
2. Tilt the mixing head back and remove the mixing wand by gently pulling it out of
the mixing head.
3. Wash the mixing wand and cup in hot, soapy water. Rinse and dry thoroughly.
Do not wash any parts in the dishwasher.
4.
If needed, wipe the mixing head with a damp cloth. Do not use harsh or abrasive
cleaners, or damage may occur to the appliance. Do not immerse the mixing
head in water or any other liquid.
4
P
RODUCT WARRANTY
Appliance 1 Year Limited Warranty
Focus Electrics, LLC (“Focus Electrics”) warrants this appliance from failures in the material
and workmanship for one (1) year from the date of original purchase with proof of purchase,
provided the appliance is operated and maintained in conformity with the provided Instruction
Manual. Any failed part of the appliance will be repaired or replaced without charge at Focus
Electrics’ discretion. This warranty applies to indoor household use only.
This warranty does not cover any damage, including discoloration, to any non-stick surface of
the appliance. This warranty is null and void, as determined solely by Focus Electrics if the
appliance is damaged through accident, misuse, abuse, negligence, scratching, or if the
appliance is altered in any way.
THIS WARRANTY IS IN LIEU OF ALL IMPLIED WARRANTIES, INCLUDING WARRANTIES
OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, PERFORMANCE, OR
OTHERWISE, WHICH ARE HEREBY EXCLUDED. IN NO EVENT SHALL FOCUS
ELECTRICS BE LIABLE FOR ANY DAMAGES, WHETHER DIRECT, INDIRECT,
INCIDENTAL, FORSEEABLE, CONSEQUENTIAL, OR SPECIAL, ARISING OUT OF OR IN
CONNECTION WITH THIS APPLIANCE.
If you think the appliance has failed or requires service within its warranty period, please
contact the Focus Electrics Customer Service Department at (866) 290-1851, or e-mail us at
service@focuselectrics.com. A receipt proving the original purchase date will be required for all
warranty claims, hand written receipts are not accepted. You may also be required to return
the appliance for inspection and evaluation. Return shipping costs are not refundable. Focus
Electrics is not responsible for returns lost in transit.
Replacement parts, if available, may be ordered directly from Focus Electrics, LLC several
ways. Order online at www.focuselectrics.com, e-mail service@focuselectrics.com, over the
phone by calling (866)290-1851, or by writing to:
Focus Electrics, LLC
Attn: Customer Service
P. O. Box 2780
West Bend, WI 53095
To order with a check or money order, please first contact Customer Service for an order total.
Mail your payment along with a letter stating the model or catalog number of your appliance,
which can be found on the bottom or back of the unit, a description of the part or parts you are
ordering, and the quantity you would like. Your check should be made payable to Focus
Electrics, LLC.
Your state/province’s sales tax and a shipping fee will be added to your total charge. Please
allow two weeks for processing and delivery.
This manual contains important and helpful information regarding the safe use and care of your
new Focus Electrics product. For future reference, attach dated sales receipt for warranty proof
of purchase and record the following information:
Date purchased or received as gift: _______________________________________________
Where purchased and price, if known: _____________________________________________
Item number and Date Code (shown bottom/back of product):___________________________
Valid only in USA and Canada
R
EPLACEMENT PARTS
L5801C 11/11 West Bend®, a Brand of Focus Electrics, LLC. Printed in China
5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.