Wells MW14, WVSW Installation Manual

WELLS BLOOMFIELD, LLC

10 Sunnen Dr., St. Louis, MO 63143

telephone: [phone]

fax: [phone]

www.wells-mfg.com

533

SUPPLEMENTAL INSTALLATION INSTRUCTIONS

MODEL WVSW VENTLESS HOOD

for

HOLMAN MM14 and QT14 CONVEYOR SANDWICH WARMER

Wells WVSW Ventless Hood

Configured for use on

Holman MM14 Sandwich Warmer

THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL

PERSONS INSTALLING THIS APPLIANCE.

Refer to Owners Manual for WVSW (p/n 2M-305812) for information concerning

operation, use and care, and maintenance of this equipment.

2M-305826 Rev. B M531 091008

INSTALLATION

NOTE: DO NOT discard

the carton or other packing
materials until you have
inspected the hood for hidden
damage and tested it for
proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of the
owners manual.

CAUTION!

RISK OF

PERSONAL INJURY
AND PROPERTY
DAMAGE

Unplug conveyor warmer and
allow to cool before beginning
installation.

UNPACKING & INSPECTION

This instruction supplements the installation instructions in Owners
Manual for WVSW (p/n305812) Carefully read all instructions in the
owners manual and this instruction before starting any installation.

Carefully remove the accessories from the carton.
Remove all protective plastic film and packing materials from the

hood before performing any installation procedure.
Carefully account for all components and accessories before

discarding packing materials.
COMPONENTS IN THIS KIT:

ADAPTER TOP FOR HOLMAN QT14 WARMER
ENTRY CANOPY
EXIT CANOPY

COMPONENTS SHIPPED WITH HOOD:
HIGH EFFICIENCY FILTER
CHARCOAL FILTER

SETUP

The Holman QT14 Sandwich Warmer requires an adapter top for
mounting the hood. Place adapter top on oven before setting hood in
place. The Holman MM14 Sandwich Warmer does not require an
adapter top.

Orient hood so that power switch is on the same side as the power
switch of the warmer. Center hood over the body of the warmer as
shown in Fig. 2 below:

Fig. 2 Hood installation on warmer
Check high efficiency filter and charcoal filter for proper installation.

Charcoal filter slides into clips on the high efficiency filter. Airflow
marks must point "up".

Attach entry and exit canopies to pins on sides of hood. Canopies are
interchangeable and may be mounted at either end, depending on the
direction of product flow. The short canopy is the ENTRY canopy, and
the long canopy is the EXIT canopy.

Maintain required clearances of at least 6" between the appliance and
adjacent combustible surfaces.

2