Welch Allyn 48650 User manual

\v,f
Diagnostic Instruments
Height Adjustable
Welch Allyn
LOCKING CASTER
NON-L&KING
CASTER
Mobile Stand Assembly Instructions
Model 48650 & 48160
NON-LOCKING
CASTER
FIGURE 1
Components
Column (includes mounting plate for model 48650 or adaptor sleeve for model 48160)
Base Locking Casters (2) Non-Locking Casters (3) Weight
inches (.64cm) Lock Washer
.25
.75
inches (1.9cm) Flat Washer
Socket Head Bolt
Hex Socket Wrench
Caster/Base Assembly Instructions:
Push casters into the holes of the base until they “snap”
into place. Alternate casters as shown in figure 1.
Base/Column Assembly Instructions:
Insert column into center hole of base.
1. Hold weight on bottom side of base so that the tapered
2. end is facing out as shown in figure 2.
Insert
.25
3. flat washer and 3 inches into center hole of weight. Tighten socket head bolt with hex socket (Allen) wrench included.
To set stand to desired height, loosen locking ring by
4. rotating counterclockwise. Adjust column to desired
height. To tighten, rotate locking ring clockwise.
inches (.64cm) lock washer,
(7.62cm)
.75
inches
long socket head bolt
(1.9cm)
COLORED STICK
.75
INCHES FLAT WASHER
INCHES
.25
LOCK WASHER
Printed in USA
(.64CM)
HEXSOCKET WRENCH
(ALLEN WRENCH)
(1.9CM)
FIGURE 2
/--
/
\
NOTE: This end only,
-Mounting plate provided with model 48650
-Adapter sleeve provided with model 48160
Welch Allyn
Welch Allyn, Inc.
4341 State Street Road
PO. Box 220
Skaneateles Falls, New York 13153-0220 USA
Telephone: (315) 685-4560
Fax: (315) 685-3361
Part No. 485647-2
Loading...