Weider WEIGHT RACK Owner's Manual
Assembly Instructions For WEMC21080 Weight Stand
5. Insert one end of a Dumbbell (10) into one of the holes in the
center upright on the Barbell Frame (1). Push the Dumbbell in
as far as it will go.
1. Press a Square Inner Cap (3) into each of
the open ends on the Barbell Frame (1)
and the Weight Frame (2).
2. Attach the two Short Connectors (4) to the
brackets on the top ends of the Barbell
Frame (1) and the Weight Frame (2) with
four Bolts (5), four Washers (6) and four
Nylon Locknuts (7). Do not tighten the
Nylon Locknuts yet.
3
5
6
6
7
3
3. Insert the two Round Connectors (8) into
1
the indicated holes in both Frames
(1 and 2).
3
10
Bracket
7
4
4
6
3
6. Line up the other end of the Dumbbell (10) with the corresponding hole in the outer upright on the Barbell Frame (1).
Push the Dumbbell halfway into this hole, so it is centered in
the space between the uprights.
2
1
10
1
8
8
5
6
7
6
9
5
5
6
3
7
9
6
7
3
Bracket
5
4. Attach the two Long Connectors (9) to the
3
7
6
5
3
brackets on the lower ends of the Barbell
Frame (1) and the Weight Frame (2) with
four Bolts (5), four Washers (6) and four
Nylon Locknuts (7). Tighten all Nylon
Locknuts used so far.
7. Secure the Dumbbell by attaching a ÒUÓ-Bolt (11) to the brack-
et on the center upright with two Nylon Locknuts (7).
Repeat this procedure until all slots on both sides of the center upright are filled up with Dumbbells (10).
8. Place a Barbell (12) one one of the weight rests on the
Barbell Frame (1).
Secure the Barbell (12) by attaching two ÒUÓ-Bolts (11) to the
brackets on the outer uprights with four Nylon Locknuts (7).
WEIDER is a registered trademark of ICON Health & Fitness, Inc.
1
7
11
12
11
1
10
7
7
11
Part No. 148695 H03301-C R1098A Printed in USA © 1998 ICON Health & Fitness, Inc.
Loading...