Weed Eater 545186757 User Manual

R Trademark
Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l’outil au détaillant.
1-800-554-6723
www.weedeater.com
Instruction Manual
Manual de Instrucciones
ENGLISH
Manuel d’Instructions
TWIST ’N EDGE
TWIST ’N EDGE
CORDLESS
CORDLESS
WARNING:
Read and follow all Safety Rules and Operating Instructions before using this product. Read instructions carefully before assembling. Failure to do so can result in serious injury.
ADVERTENCIA:
Lea el manual del operador y siga todas las advertencias e instruc­ciones de seguridad. Antes de ensamblar el producto lea cuidado­samente el instructivo. El no hacerlo puede resultar en lesiones gra­ves.
AVERTISSEMENT:
Veuillez lire le manuel de l’utilisateur et bien respecter tous les avertissements et toutes les instructions de sécurité. Bien lire les instructions avant d’assembler l’outil. Tout défaut de le faire pourrait entraîner des blessures graves.
WEED EATER 1030 Stevens Creek Road Augusta, GA 30907
850 Matheson Blvd. West
Mississauga, Ontario L5V 0B4
WEED EATER
R
R
545186757 Rev. 2 3/4/09 BRW
IDENTIFICATION OF SAFETY SYMBOLS
DANGER: Use only specified trimmer head,
spool, and 0.065 inch (1.65 mm) recommended trimmer line. Never use blades, flailing devices, wire, rope, string, etc. Unit is designed for line trim­mer use only. Failure to follow these instructions may result in serious injury.
WARNING: This unit can be dangerous! Careless or improper
use can cause serious injury.
Read the operator ’s manual before use. Failure to follow instructions could result in serious injury. Save operator’s manual.
To reduce the risk of electric shock, do not expose unit to water. Do not operate unit on wet ground or in rain.
Trimmer line can throw objects violently. You can be blinded or injured. Always wear hearing protection and safety glasses marked Z87. Always wear heavy, long pants, long sleeves, boots and gloves.
Hazard zone for thrown objects.
S Trimmer line throws objects violently. S You and others can be blinded/injured. S Keep children, bystanders, and animals
50 feet (15 meters) away.
Secure hair above shoulder length. Do not wear jewelry, loose clothing, or clothing with loosely hanging straps, ties, tassels, etc. They can be caught in moving parts.
Stop unit before cleaning or servicing. Keep hands and fingers away from the trigger switch to avoid accidental starting during cleaning or servicing.
2
IDENTIFICATION OF SAFETY SYMBOLS
Do not use with damaged cord. Repair or replace damaged cord immediately.
Store unit indoors in a high, dry place out of the reach of children. Store unit unplugged.
This unit is for household use only and not for commercial use.
When servicing unit, use only identical replace­ment parts.
Never allow children to operate this unit.
SAFETY RULES
WARNING: When using electric gar-
dening appliances, basic safety precautions must always be followed to reduce the risk of fire, electric shock, and serious injury. Read and follow all instructions.
SAFETY INFORMATION ON THE UNIT
This power unit can be dangerous! Operator is responsible for following the warnings and instructions in this manual and on the unit. Read entire instruction manual before using unit! Be thoroughly familiar with the controls and the proper use of the unit. Restrict the use of this unit to persons who read, understand, and follow unit and manual warnings and instructions. Never allow children to operate this unit. Close attention is necessary when used near children.
DANGER: Never use blades or flail-
ing devices. Unit is designed for line trimmer use only. Use of any other accessories or at­tachments will increase the risk of injury.
WARNING: Trimmer line throws ob-
jects violently. You and others can be blinded/ injured. Wear safety glasses, boots, and leg protection. Keep body parts clear of rotating line. Keep children, bystanders, and animals 50 feet (15 meters) away. If approached stop unit immediately. If situations occur which are not covered in this manual, use care and good judgement. If you need assistance, call 1-800-554-6723.
3
OPERATOR SAFETY
S Dress properly. Always wear safety
glasses or similar eye protection when op­erating, or performing maintenance on your unit. (Safety glasses are available.) Always wear face or dust mask if operation is dusty. Always wear heavy, long pants, long sleeves, boots, and gloves. Do not go bare­foot or wear sandals.
S Secure hair above shoulder length. Secure or
remove loose clothing and jewelry or clothing with loosely hanging ties, straps, tassels, etc. They can be caught in moving parts.
S Being fully covered also helps protect you
from debris and pieces of toxic plants thrown by spinning line.
S Stay alert. Do not operate unit when you are
tired, ill, upset or under influence of alcohol, drugs, or medication. Watch what you are doing; use common sense.
S Avoid unintentional starting of the unit.
Keep hands and fingers away from the trig­ger switch while carrying the unit.
ELECTRICAL SAFETY
WARNING: Av oid a dangerous envi-
ronment. T o reduce the risk of electrical shock, do not use on wet grass. Do not use in rain, in damp or wet locations, or around swimming pools, hot tubs, etc. Do not expose to snow, rain, or water to avoid the possibility of electrical shock. S Only use the charger provided with your
unit when charging the battery. Use of any other charger could permanently damage the battery, charger, and/or the unit.
S Use charger with standard household electri-
cal outlets only (120 volt). Do not abuse the charger or charger cord. Never carry the unit by the charger cord or yank cord to discon­nect from receptacle. Do not use the charger if the charger or charger cord is damaged.
S Use the charger indoors only. S Store and charge this unit in a dry location
and out of the reach of children.
S Avoid dangerous situations. Do not charge
the battery or use the unit in an explosive or corrosive environment. Avoid areas where flammable liquids or gases are present to avoid creating a fire or explosion and/or causing damage to unit.
S Do notoperate unit while it is attached to the
charger.
S Do not attempt to repair unit, battery or char-
ger. Inspect insulation and connectors on the unit and charger before each use. If there is any damage, do not use until damage is re­paired by your authorized service dealer.
S Do not insert any object into the motor area. S Battery-powered units do not have to be
plugged into an electrical outlet to operate; therefore, they are always in operating condi­tion. Be aware of possible hazards when you are not using your battery-powered unit.
S Do not dispose of the battery in a fire. The cell
may explode. Check with local code for prop­er disposal. Do not open or mutilate the bat­tery. Released electrolyte is corrosive and
may cause damage to the eyes or skin. It may be toxic if swallowed.
S When handling batteries, take care not to
short the battery with conducting materials such as rings, bracelets, and keys. The bat­tery or conductor may overheat and cause burns.
S Do not use the unit if the trigger switch does
not turn the unit on and off properly. Repairs to the switch must be made by your authorized service dealer.
S Never immerse any part of the unit or char-
ger into any liquid.
S Inspect charger cord periodically and if
damaged, have it repaired or replaced by an authorized service dealer.
S Disconnect charger from receptacle when
not in use to reduce the risk of electric shock or serious personal injury.
UNIT SAFETY
S Inspect unit before use. Replace damaged
parts. Make sure all handles, guards, and fasteners are in place and securely fas­tened. Parts that are damaged must be re­paired or replaced by an authorized service dealer These include head parts that are cracked, or chipped, guards, and any other part that is damaged.
S Do not repair unit yourself. S Use only 0.065 inch (1.65 mm) diameter
recommended trimmer line (see USER RE­PLACEABLE SERVICE PARTS in the SERVICE AND ADJUSTMENTS section). Never use wire, rope, string, etc.
S Use specified trimmer spool. Make sure
spool is properly installed and all parts are securely fastened.
S Use only WEED EATER replacement parts
and accessories as recommended.
CUTTING SAFETY
WARNING: Inspect area to be cut.
Remove objects (rocks, broken glass, nails, wire, string, etc.) which can be thrown or be­come entangled in cutting head. S Do not overreach or stand on unstable sup-
port. Keep firm footing and balance.
S Keep the cutting head below waist level. Do
not raise handles above your waist. Cutting head can come dangerously close to your body.
S Keep away from cutting head and spinning
line.
S Use unit properly. Use only for trimming,
scalping, and mowing. Do not force unit. It will do the job better and with less risk of in­jury at the rate for which it was designed.
S Use only in daylight or in good artificial light.
MAINTENANCE SAFETY
WARNING: Stop unit before per-
forming maintenance. Keep hands and fin­gers away from the trigger switch to avoid ac­cidental starting during maintenance, or when changing trimmer line. S Maintain unit according to recommended pro-
cedures. Keep cutting line at proper length. Follow instructions for changing trimmer line.
4
S Have all service and maintenance not ex-
plained in this manual performed by an autho­rized service dealer to avoid creating a haz­ard.
S Never douse or squirt the unit with water or
any other liquid. Clean unit and labels with a damp sponge. Keep handles dry, clean, and free from oil and grease.
S Keep the air vents clean and free of debris to
avoid overheating the motor. Clean after each use.
TRANSPORTING AND STORAGE
S Stop the unit and place in wall bracket for
storage and battery charging.
S Carry the unit with motor stopped. S Store unit indoors in a high, dry place out of
the reach of children.
S Do not hang unit so that the trigger switch is
depressed.
BATTERY CARE
S If over a period of time the battery quickly
runs down after a full 24 hour charging peri­od, a replacement battery is needed.
S There will be some charge present in the bat-
tery, but to ensure maximum running time, re­charge your battery for 24 hours before use.
S Permanent connection to the charger in a
well- -ventilated area will automatically keep your battery fully charged and ready for use.
ASSEMBLY
WARNING: If received assembled,
review all assembly steps to ensure your unit is properly assembled and all fasteners are secure.
SHAFT ASSEMBLY
WARNING: Ensure that the excess
wire between the switch handle and motor housing is not twisted and is enclosed in switch handle and motor housing during assembly of the unit. Failure to do so may result in damage to the wires and/or the unit or serious injury to the operator.
1. Push the tube into the switch handle until it snaps into place.
Switch Handle
Tube
S To prevent permanent battery damage, never
store in a discharged condition.
S Battery
Sealed for Life No maintenance required
S Battery replacement
Should your battery need to be replaced, contact your authorized service dealer for a replacement battery and for proper dispos­al of the old battery.
WINTER STORAGE
S Fully charge for 24 hours before winter stor-
age.
S If you are unable to leave your cordless
trimmer on permanent charge, recharge the battery every 3 to 4 months for a full 24 hour charging period to fully charge the bat­tery during winter storage.
S Avoid extended storage without recharge. S Store in a cool dry place.
IMPORTANT! DISPOSE OF YOUR OLD BATTERIES SAFEL Y. TAKE THE COMPLETE UNIT TO YOUR AUTHORIZED SER VI CE DEALER. DO NOT CUT OPEN, BURN OR INCINERATE.
SAVE THESE INSTRUCTIONS
2. Push the tube into the motor housing until it snaps into place.
Motor Housing
3. Try to remove tube from switch handle and motor housing. If the tube remains in place, it is properly snapped into place. If the tube will not remain in place, repeat steps 1 and
2. Push until the tube snaps into place.
ATTACHING THE SHIELD
WARNING: The shield must be prop-
erly installed. The shield provides partial protec­tion from the risk of thrown objects to the opera­tor and others. Your unit is equipped with a line limiter pin, which cuts excess line to the proper length while running.
NOTE: If shield is not properly installed, dam-
age to unit (including motor failure) will result.
1. Place the shield onto the motor housing. Ensure the cutting head remains free to rotate and the line is not caught between the shield and the motor housing (see il­lustration).
Tube
5
Loading...
+ 9 hidden pages