Weber 39935 User Manual

®
®
DANGER
Please read the following warnings carefully before using your FirePlace. Failure to follow these
warnings may result in serious bodily injury or death, or in a fire causing damage to property.
WARNINGS
The Weber FirePlace is designed solely for
Use only on noncombustible surfaces,
such as brick, flagstone, concrete, etc. Do not use on a wooden deck.
Keep away from flammable materials,
buildings and vehicles when in use.
Exercise the same care that you would
with an open campfire.
Your Weber FirePlace is not to be used by
children.
Keep away from flammable fluids such as
gasoline, charcoal lighter fluid and alcohol, etc.
Keep children and pets away from the
FirePlace when in use.
Never wear loose-fitting or flammable
clothing (such as nylon) when in use.
Do not overload. Before starting the fire
make sure the lid is capable of closing. Overloading can be dangerous if the lid cannot extinguish the fire.
Do not use soft woods, like pine or cedar.
Soft woods may "pop" and throw sparks.
Do not burn leaves, paper, plywood or
trash in the Weber FirePlace.
Do not use volatile fluids, such as
gasoline, charcoal lighter fluid or alcohol, to light or relight fires.
Use only sturdy, long-handled fireplace
equipment, when adding or moving logs.
Do not attempt to move the FirePlace when
in use or hot.
Use barbecue mitts when handling,
because surfaces will be hot when in use.
Fill the Weber FirePlace bottom with
approximately two pounds of sand before use. This helps to insulate the bottom of the FirePlace.
Always extinguish fire with the lid. Do not
douse with water; this will fracture the porcelain finish. Wood fires take a long time to extinguish. The Weber FirePlace and the ashes inside may remain hot for some time. Leave the lid closed until the Weber FirePlace is cold.
Do not store the Weber FirePlace with
combustible materials or ashes inside.
®
®
39935 10/93
FirePlace Assembly
Instructions
Assembly
Tools needed
Screwdrivers, regular
and Phillips
7/16 inch open-end or an adjustable wrench
Two steel handles
Two top wood handles
Two bottom wood handles
Two wood screws
Sixteen large fiber washers
Eight small fiber washers
Twenty 1/4 inch steel washers
Twenty-four 1/4-20 hex nuts
Twenty-four 1/4-20 x 5/8 inch machine screws
Step 2
Install Steel Handles
You will need: lid, eight small fiber washers, eight steel washers, two steel handles, four machine screws, four hex nuts, a regular screwdriver and wrench.
Install handles as shown in Figure 1.
CAUTION: Do not overtighten; you may crack the porcelain finish.
Figure 1
Machine screw
Steel handle
Steel washer
Steel washer
Hex nut
Small fiber washers
®
®
Step 1
Check Package Contents
You should have received the parts shown below with your Weber FirePlace. In the unlikely event a part is missing or damaged, do not return the FirePlace, instead contact:
WEBER-STEPHEN PRODUCTS COMPANY
Customer Service Center 250 South Hicks Road Palatine, IL 60067-6241 (708) 705-8660
(800) 446-1071
Parts
Lid
Upper support ring
Four uprights
Lower support ring
Bottom
Heat deflector
Four legs
Loading...
+ 2 hidden pages