WALL MOUNT FAUCET INSTALLATION GUIDE
BEFORE YOU BEGIN
1)Shut off water supply.
2)Carefully inspect waste and supply tubing for signs of damage.
3)Replace waste or supply tubing if necessary
A)VALVE BODY INSTALLATION
1)Prepare for installation by installing a wood crossmenber between two studs where the valve will mount.
Important : Take into consideration the thickness of your finished wall. If your valve is installed too far behind your finished wall, you may
be left with insufficient clearance to attach the spout and handles.
MODEL: F4-0001
Recommended Tools:
-Drill
-Hack Saw
-Level
-Tape Measure
-Safety Glasses
2)Mount the rough-in valve into its prepared location. Attach the valve body to the crossmember by using galvanized pipe clamps (not included) . Use a level to ensure the valve is mounted straight.
3)Attach the main water lines to the valve. Apply thread sealant or Teflon
tape to the threaded connection to ensure a watertight seal.
CROSSMEMBER
(to be installed by installer)
1/2-14 NPS |
|
|
|
|
|
|
|
|
|
|
|
WALL THICKNESS |
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
MAX. 7/8” (22mm) |
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
1-5/8” (42mm) |
STUD
GALVANIZED PIPE CLAMP