P-269-2
819-0410
Remote Accessory Potentiometer for
CBC-300 Controls
Installation & Operating Instructions
An Altra Industrial Motion Company
Failure to follow these instructions may result
in product damage, equipment damage, and serious or fatal
injury to personnel.
Part Numbers
6011-101-001 5K ohm remote accessory potentiometer, 1 turn for level adjust on
CBC-300-2, CBC-300-C2, CBC-300-3, and CBC-300-C3.
6011-101-002 10k ohmΩ remote accessory potentiometer 1 turn for current adjust on CBC-300-1,
CBC-300-C1, CBC-300-3, and CBC-300-C3.
Specifications
6011-101-001 5k ohm, potentiometer, 2 watts, 10% tol. single turn, bushing mounted
6011-101-002 10 k ohm potentiometer, 2 watts, 10% tol. single turn, bushing mounted
Cable Length
10 ft. 22 GTAWY, 3 conductor with shield,
60º C rating.
Mounting
Panel mounted via 3/8 – 32 bushing on
potentiometer
General
The remote accessory potentiometer provide for
remote operation of specific CBC-300 controls,
combination of one or both potentiometers allow
for adjustment of the output current or level
applied to clutch or brake. The 5k potentiometer
allows for level adjustment of both output’s
between zero and maximum level. The 10k
potentiometer is used for adjusting the current
output.
Mounting and Installation
Select a location where the potentiometer is to be
mounted. This should be such that it is within the
allowable cable length supplied.)
Note: It is not recommended to splice the cable
for longer wiring runs. If the cable length is not
sufficient, then either mount the control closer to
the potentiometer or relocate the potentiometer
closer to the control.
Figure 1
2 Warner Electric • 800-825-9050 P-269-2 • 819-0410
o
1. Select mounting location
o
o
o
o
o
o
o
o
2. Mark panel per Figure 1
3. Drill hole, Ø.3860” diameter for 3/8 bushing
4. Locate retaning hole and drill a Ø.1360” diameter hole
5. Mount potentiometer and secure with lockwasher and nut
6. Rotate potentiometer shaft fully counter-clockwise (CCW)
7. Attach knob with indicator to approximate 7 o’clock position
8. Tighten 6-32 set screw in knob.
Note: No face plate or markings are supplied. Customer to provide appropriate reference as
desired.
9. Run wires between remote potentiometer and control using standard control practices avoiding
runs with high voltage AC, motor or drive wiring and switching circuits
o
Prior to powering up unit, double check mounting
to insure potentiometer lugs are not contacting
anything in its proximity, wiring is run properly,
and connections are made in accordance to the
proper wiring section of the controls manuals.
For further technical assistance, contact your
local Warner Electric Distributor, Warner Electric
Representative or the Technical Support Group at
the factory.
10. Wire untermirated end to control terminal block per appropriate wiring sections of the control
manual, P-269 or P-269-1
This completes the installation and wiring of your remote potentiometer assembly.
Warner Electric • 800-825-9050 P-269-2 • 819-0410 3
Warranty
Warner Electric LLC warrants that it will repair or replace (whichever it deems advisable) any product
manufactured and sold by it which proves to be defective in material or workmanship within a period of one (1)
year from the date of original purchase for consumer, commercial or industrial use.
This warranty extends only to the original purchaser and is not transferable or assignable without Warner Electric
LLC’s prior consent.
Warranty service can be obtained in the U.S.A. by returning any defective product, transportation charges
prepaid, to the appropriate Warner Electric LLC factory. Additional warranty information may be obtained by
writing the Customer Satisfaction Department, Warner Electric LLC, 449 Gardner Street, South Beloit, Illinois
61080, or by calling 815-389-3771.
A purchase receipt or other proof of original purchase will be required before warranty service is rendered. If
found defective under the terms of this warranty, repair or replacement will be made, without charge, together
with a refund for transportation costs. If found not to be defective, you will be notified and, with your consent, the
item will be repaired or replaced and returned to you at your expense.
This warranty covers normal use and does not cover damage or defect which results from alteration, accident,
neglect, or improper installation, operation, or maintenance.
Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply
to you.
Warner Electric LLC’s obligation under this warranty is limited to the repair or replacement of the defective
product and in no event shall Warner Electric LLC be liable for consequential, indirect, or incidental damages of
any kind incurred by reason of the manufacture, sale or use of any defective product. Warner Electric LLC neither
assumes nor authorizes any other person to give any other warranty or to assume any other obligation or liability
on its behalf.
WITH RESPECT TO CONSUMER USE OF THE PRODUCT, ANY IMPLIED WARRANTIES WHICH THE
CONSUMER MAY HAVE ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL
CONSUMER PURCHASE. WITH RESPECT TO COMMERCIAL AND INDUSTRIAL USES OF THE PRODUCT,
THE FOREGOING WARRANTY IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES, WHETHER
EXPRESSED OR IMPLIED BY OPERATION OF LAW OR OTHERWISE, INCLUDING, BUT NOT LIMITED TO,
ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you. This warranty gives you specific legal rights and you may also have
other rights which vary from state to state.
Changes in Dimensions and Specications
All dimensions and specifications shown in Warner Electric catalogs are subject to change without notice.
Weights do not include weight of boxing for shipment. Certified prints will be furnished without charge on request
to Warner Electric.
www.warnerelectric.com
31 Industrial Park Road
New Hartford, CT 06057
800-389-3771
Fax: 815-389-2582
P-269-2-WE 819-0410 3/14 Printed in USA
An Altra Industrial Motion Company
www.altramotion.com
Loading...