For your safety and continued enjoyment of this product,
always read the instruction book carefully before using.
Para su seguridad y para disfrutar plenamente de este producto,
siempre lea las instrucciones cuidadosamente antes de usarlo.
An que cet appareil vous procure en toute sécurité beaucoup de satisfaction,
lire attentivement le mode d’emploi avant de l’utiliser.
PBB
MBB
IMPORTANT UNPACKING
INSTRUCTIONS
IMPORTANT: Always unplug the Waring Pro
Blender from outlet when disassembling and assembling.
®
1. Place the gift box containing your Waring Pro® Blender on a
at, sturdy surface before unpacking.
2. Open corrugated ap. Remove blender container assembly,
instruction booklet and other printed materials from top of
corrugated box. Please use caution not to tip the container
when removing. CAUTION: Sharp blade inside blender jar.
3. Next, remove the top corrugated insert. Carefully lift
blender base from box and set aside.
4. Replace all corrugated inserts in the box and save the box
for repacking.
Note: for WPB Series blenders, follow instructions, How to
Assemble Containers with Removable Blades, page 5.
REPACKING INSTRUCTIONS
1. Place the unit on a large, sturdy at surface.
2. Carefully place blender base in bottom of box.
3. Place corrugated insert over base.
4. Place blender container assembly over corrugated insert
and cover with corrugated ap.
When using electrical appliances, basic safety precautions
should always be followed, including the following:
1.
READ ALL INSTRUCTIONS.
2. Unplug from outlet when not in use, before putting on
or taking off parts, and before cleaning.
3. To protect against risk of electrical shock, do not put
appliance in water or other liquid.
4. Do not use carbonated liquids in the blender jar, or
any blending container. Using carbonated liquids in
the blender jar or any blending container may result
in injury.
5. This appliance should not be used by or near children or
individuals with certain disabilities.
6. Avoid contact with moving parts.
7. Do not operate the Waring Pro
electrical appliances with a damaged cord or plug, or after
the unit malfunctions, or is dropped or damaged in any
manner. Return it to the nearest authorized service facility
for examination, repair, or adjustment.
8. The use of attachments, including canning jars, not
recommended or sold by Waring Pro may cause re,
electric shock, or injury.
9. Do not use outdoors.
10. Do not let cord hang over edge of table or counter, or
touch hot surfaces.
11. Keep hands and utensils out of jar while blending to
prevent the possibility of severe personal injury and/or
damage to the blender. A rubber spatula may be used,
but must be used only when the blender is not running.
12. Blades are sharp. Handle carefully.
®
Blender or any other
2
3
13. To avoid injury, never place blade assembly on the base
without container properly attached.
14. Always operate blender with cover in place.
15. When blending hot liquids, remove center piece of
two-piece cover. Begin processing with only one cup
(8 oz.). Always begin processing at the lowest speed
setting. Keep hands and other exposed skin away from the
lid opening to prevent possible burns. See Hot Blending
instructions, next page.
16. Screw on container bottom rmly. Injury can result if
moving blades accidentally become exposed.
17. Do not leave blender unattended while it is running.
18. Do not operate your appliance in an appliance garage
or under a wall cabinet.When storing in an appliance
garage, always unplug the unit from the electrical
outlet. Not doing so could create a risk of re, especially if
the appliance touches the walls of the garage or the door
touches the unit as it closes.
adapter, it must be determined that the outlet cover plate screw
is properly grounded. If in doubt, consult a licensed electrician.
Never use an adapter unless you are sure it is properly
grounded.
Note: Use of an adapter is not permitted in Canada.
This appliance is for 120 volts only and should not be used with
a converter.
IMPORTANT: HOT BLENDING INSTRUCTIONS
To minimize possibility of scalding when blending hot
ingredients, the following precautions and procedures must be
observed:
1. Limit amount of material processed to one cup (8 oz.).
2. Completely remove the lid insert of the two-piece container
lid before starting motor. (This will allow venting of the
rapidly heated and expanding air present inside container
when blender is running.)
3. Start blending on low speed.
4. While blender is running, up to 1½ cups (12 oz.) of
additional liquid can be added. Pour liquid slowly through
the opening in the lid.
SAVE THESE INSTRUCTIONS
GROUNDING INSTRUCTIONS
For your protection, Waring Pro® Blenders are equipped
with a 3-conductor cordset that has a molded 3-prong
grounding-type plug, and should be used in combination with a
properly connected grounding-type outlet as shown in Figure 1.
If a grounding-type outlet is not available, an adapter, shown in
Figure 2, may be obtained so that a 2-slot wall outlet can
be used with a 3-prong plug. Referring to Figure 3, the adapter
must be grounded by attaching its grounding lug under the
screw of the outlet cover plate. CAUTION: Before using an
4
OPERATING INSTRUCTIONS
1. When placing the container on the unit base, make sure
that the unit is turned off and is at a complete stop. Do not
put the container on or take it off while the unit is running.
Doing so may damage the drive shaft or blade assembly.
For best results, do not ll container above
3-cup level.
2. Be sure the switch is in the off position and plug the
blender into a convenient outlet.
3. The Waring Pro
A hint when mixing ice drinks: keep the blades in the
container covered with liquid, turn the unit on, remove the
lid insert on top of the jar lid, and feed the ice cubes slowly
into the jar. NOTE: Never use containers other than Waring
®
Pro
Blender containers with your Waring unit.
®
Blender is ideal for blending ice drinks.
5
4. CAUTION: DO NOT use carbonated liquids in the blender
jar or any blending container.Using carbonated liquids in
the blender jar or any blending container may result in injury.
5. Put ingredients into container, then put on cover. Always
add liquid ingredients rst, unless otherwise specied in
recipe. Always hold container with one hand while blending.
6. CAUTION: To avoid damage to your blender, do not run the
blender if the blades become blocked or jammed during
use. Turn the blender off immediately, remove the container
from the blender base and dislodge the material that is
blocking or jamming the blade.
HOW TO ASSEMBLE CONTAINERS
WITH REMOVABLE BLADES
1. Before starting, make sure that the
blender cord is unplugged and that
the switch is in the off position.
2. Refer to Figure 1. The following
points are important to note when
putting together the container
assembly:
3. Container gasket must be between
the blade assembly and the
container.
4. Container collar must not be
misthreaded onto the container.
5. Container collar must be securely
tightened onto the container
before placing food or liquid in the
container.
6. Tighten the container collar by holding the container upside
down and turning the container collar
counterclockwise.
7. Place container assembly on unit base so that it is rmly
seated and not tilted to one side. Never place the container
collar or the blade assembly on the unit base unless the
container has been completely assembled and securely
tightened.
Fig .1
HOW TO DISASSEMBLE & CLEAN
CONTAINERS WITH REMOVABLE BLADES
1. Be sure the switch is in the off position.
2. Remove the container assembly from the unit base and
empty the contents.
3. To disassemble the Waring Pro
assembly, turn container collar clockwise.
4. The glass container, container collar and blade assembly
are dishwasher safe. The plastic container, lid, measuring
cup lid insert and gasket must be washed by hand. Allow
all parts to air dry, and reassemble for next use.
5. When assembling container after cleaning, be certain all
components are in the proper position.
6. It is particularly important to place the container gasket
between the blade assembly and the container.
7. Wash and rinse container prior to initial use, and
immediately after each use.
®
Blender container
HOW TO CLEAN CONTAINERS WITH
NONREMOVABLE BLADES
1. Remove the container from the unit base. Remove the
lid. Add a cup of cleaning solution, made by adding a few
drops of dishwashing detergent to 1 cup of cool water,
to the container. Scrub and ush out the interior of the
container and the lid to dislodge and remove as much
residue as possible. Empty the container.
2. Add more cleaning solution. Put lid on container, place
container on unit base, and run on high speed for
two minutes.
3. Empty the container and repeat as above, using clean rinse
water in place of cleaning solution. Empty, rinse and dry,
prior to storing unit.
4. Wash and rinse container prior to initial use, and
immediately after each use.
6
7
HOW TO CLEAN UNIT BASE
To clean the unit base, unplug the power cord. Wipe the exterior
surfaces with a soft cloth or sponge dampened with cleaning
solution. Rinse with clean water. Do not immerse the base in
cleaning solution or water. Wipe the base with dry towel.
Any other servicing should be performed by an authorized
service representative.
RECIPES
SHAKES
Chocolate Malted Shake – 2 servings
½ cup whole milk
1 tablespoon chocolate syrup
1 cup chocolate ice cream
3 tablespoons malt powder
1 teaspoon vanilla
Place ingredients in blender jar in order listed. Blend for 2 minutes
on HI.
2 mangoes, peeled, pitted, and cut into 1-inch pieces
½ cup lime juice
¼ cup apple juice
¼ cup mango juice
6 tablespoons sugar
9 ice cubes
¼ cup rum (optional)
Place all ingredients in blender jar in order listed, cover, and blend for
1–2 minutes on HI.
1 cup old-fashioned oatmeal (not instant)
1 cup flour
1 tablespoon baking powder
½ teaspoon baking soda
½ teaspoon ground cinnamon
1
⁄8 teaspoon ground nutmeg
3 tablespoons brown sugar
1½ cups buttermilk
2 large eggs
2 medium size ripe bananas, sliced
4 tablespoons butter (melted)
1 tablespoon vanilla
pinch salt
Blend ½ cup oats on HI until they reach a powdery consistency. Put
blended oats into a bowl with remaining oats and set aside. Blend the
remainder of dry ingredients until thoroughly mixed. Add to oats.
Blend buttermilk, eggs, banana, butter and vanilla on LO until smooth.
Pour wet ingredients over dry ingredients, and stir until just mixed. Do
not overmix.
Pour ½ cup of batter per waffle onto hot waffle iron. Cook. Serve
immediately, or reserve baked waffles in 200°F degree oven until all
waffles have been baked.
8 ounces sun-dried tomatoes in oil, drained
2 garlic cloves
2 tablespoons grated Parmesan cheese
½ teaspoon oregano
½ teaspoon basil
¼ teaspoon salt
3 tablespoons extra virgin olive oil
Place all ingredients in blender. Mix on HI, stopping frequently to
scrape down the sides of blender jar. Tapenade is best when paired
with cheese and bread.
1 tablespoon Dijon mustard
3 tablespoons balsamic vinegar
2 garlic cloves
½ teaspoon salt
1 cup olive oil
pepper to taste
Blend first 4 ingredients on HI for a few seconds. Then, with blender
running, remove small lid insert and pour in oil VERY SLOWLY. It will
take a while, but the results are worth it! Season with pepper.
1 garlic clove, peeled
1 shallot, peeled and cut into ½ inch-pieces
2 tablespoons fresh Italian parsley leaves
1 cup lowfat mayonnaise
½ cup buttermilk or fat-free plain yogurt
¼ cup crumbled blue cheese
½ teaspoon kosher salt
¼ teaspoon ground white pepper
dash Tabasco
Place garlic, shallot and parsley in blender container. Blend on HI for
10 seconds. Scrape blender jar and add remaining ingredients. Blend
on HI for 30–40 seconds until smooth and creamy. Let stand for 30
minutes before serving, to allow flavors to develop.
1 can (12 ounces) spicy vegetable juice
4–5 fresh plum tomatoes, quartered
1 can (14 ounces) crushed tomatoes with
roasted garlic (if available)
2 garlic cloves
1 medium onion, chopped
1 celery stalk with leaves, cut into 1-inch chunks
1 teaspoon Worcestershire sauce
1 teaspoon balsamic vinegar
½ teaspoon lemon juice
red pepper flakes to taste
salt to taste
pepper to taste
5–6 drops Tabasco
®
Place all ingredients in blender and run for 2–3 minutes on HI. If the
blender is too full, you may want to make this recipe in 2 batches.
½ cup cooked white rice
4 carrots, peeled and sliced
1 medium onion, sliced
1 celery stalk, cut into 1-inch chunks
1½ cups chicken stock
1 teaspoon salt
¾ cup light cream
cayenne pepper to taste
sour cream and diced roasted red peppers (garnish)
In a small stockpot, bring vegetables and one cup of chicken stock to
a simmer, and cook for 20–25 minutes. Let cool for 15–20 minutes.
Pour soup into blender with remaining stock, rice, salt and cayenne.
Blend on LO for 1–2 minutes, until smooth. Add cream and chill in
refrigerator to serve cold, or reheat to just below a simmer to serve
hot. Garnish with diced peppers and a dollop of sour cream.