VTech Move & Zoom Racer User Manual

User’s Manual
© 2013 VTech
Printed In China
91-002850-000 US CA
Move & Zoom Racer
TM
Introduction
INTRODUCTION
Thank you for purchasing the VTech® Move & Zoom Racer™ learning toy.
Rev your baby’s engine with the Move & Zoom Racer™ by VTech®! Baby makes the car move by shaking the smart rattle, teaching cause and effect relationships. They can also plug the rattle into the car and make it move on its own. Now they can get moving and develop their motor skills as they chase and race their way to learning fun!
OFF/VOLUME CONTROL SWITCH
SMART
RATTLE
LEARNING BUTTONS
Included In This Package/Getting Started
INCLUDED IN THIS PACKAGE
- One VTech® Move & Zoom Racer™ learning toy
- One instruction manual
WARNING: All packing materials, such as tape, plastic sheets,
packaging locks and tags are not part of this toy, and should be discarded for your child’s safety.
ATTENTION: Pour la sécurité de votre enfant, débarrassez-vous
de tous les produits d’emballage tels que rubans adhésifs, feuilles de plastique, attaches et étiquettes. Ils ne font pas partie du jouet.
NOTE: Please keep this instruction manual as it contains
important information.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the unit. Use a screwdriver to loosen the screw.
3. Install 3 new ‘AA’ (AM-3/LR6) batteries following the diagram inside the battery box. (The use of new alkaline batteries is recommended for maximum performance.)
4. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
Product Features
PRODUCT FEATURES
1. OFF/VOLUME CONTROL SWITCH
To turn the unit ON, slide the OFF/
VOLUME CONTROL SWITCH to the
low volume ( ) or high volume ( ) position. To turn the unit OFF, slide the OFF/VOLUME CONTROL SWITCH to the OFF ( ) position.
2. AUTOMATIC SHUT-OFF
To preserve battery life, the VTech® Move & Zoom Racer™ will
automatically power-down after approximately 40 seconds without input. The unit can be turned on again by pressing any button.
Activities
ACTIVITIES
1. Turn on the unit to hear car engine sound effects, playful phrases and a sing-along song.
2. Shake the smart rattle to make the car move. This toy works best when you shake the smart rattle from within a four-foot range.
3. Press the green learning button on the front of the car to learn about numbers and opposites.
4. Press the red learning button on the front of the car to hear music and learn opposites.
5. Insert the smart rattle into car. Press the rattle to hear fun phrases, music and to make the car go.
Melody List
MELODY LIST:
1. Daring Young Man on the Flying Trapeze
2. Flight of the Bumblebee
3. Yankee Doodle
4. She’ll Be Coming ‘Round the Mountain
5. Ring Around the Rosie
6. Sailing, Sailing
7. Here We Go ‘Round the Mulberry Bush
8. This Old Man
9. Teddy Bear’s Picnic
10. Did You Ever See a Lassie?
SING-ALONG SONG LYRICS
SONG 1
I’m a little racer. I like to race on the open road.
SONG 2
Time to race. Woohoo! Let’s pick up the pace!
SONG 3
Beep, beep, here I come. I won the race, I’m number one!
Care & Maintenance/Troubleshooting
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat source.
3. Remove the batteries when the unit will not be in use for an extended period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to
moisture or water.
5. This toy works best indoors on smooth surfaces.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions,
please follow these steps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit should now be ready to play again.
5. If the product still does not work, replace with an entire set of new
batteries.
If the problem persists, please call our Consumer Services Department
at 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, and a service representative will be happy to help you.
For information on this product’s warranty, please call our Consumer
Services Department at 1-800-521-2010 in the U.S. or 1-877-352-8697
in Canada.
Other Info
IMPORTANT NOTE:
Creating and developing Infant Learning products is accompanied by a responsibility that we at VTech® take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to call
our Consumer Services Department at 1-800-521-2010 in the
U.S., or 1-877-352-8697 in Canada, with any problems and/or suggestions that you might have. A service representative will be happy to help you.
NOTE :
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
10
Other Info
Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
CAN ICES-3 (B)/NMB-3(B)
Loading...