VTech LS6005 User Manual
User’s manual
T
Compatible with
Hearing Aid T-Coil
TIA-1083
LS6005/LS6005-13/
LS6005-15/LS6005-16/
LS6005-17
DECT 6.0 accessory handset for
use with VTech models LS6195
Congratulations
on purchasing your new VTech product. Before using this telephone, please read
Important safety instructions on page 5 of this manual.
This manual has instructions how to set up and register your new handset. For
complete instructions on using the handset, see the Abridged user’s manual that
came with your telephone base.
You may also view or download the online Complete user’s manual for a
full set of installation and operation instructions at www.vtechphones.com.
In Canada, visit www.vtechcanada.com.
Telephones identied with this logo have reduced noise and
interference when used with most T-coil equipped hearing
aids and cochlear implants. The TIA-1083 Compliant Logo is
a trademark of the Telecommunications Industry Association.
Used under license.
The ENERGY STAR® program (www.energystar.gov) recognizes
and encourages the use of products that save energy and help
protect our environment. We are proud to mark this product with
the ENERGY STAR® label indicating it meets the latest energy
efciency guidelines.
Register online to get an additional 3-month warranty!
Visit www.vtechphones.com.
Registration
Register your product online for enhanced
warranty support.
Product news
Learn about the latest VTech products.
1
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Parts checklist
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Your telephone package contains the following items. Save your sales receipt and
original packaging in the event warranty service is necessary.
Handset
Charger and charger adapter
Battery compartment cover
User’s manual
User’s manualBattery
Battery installation
Install the battery as shown below.
Insert the battery connector securely
1. Place the battery with the label
into the socket as shown below.
2.
THIS SIDE UP facing up and the
wires inside the battery compartment.
Slide the battery compartment cover
3.
towards the center of the handset until
it clicks into place.
If the handset will not be used for a long time, disconnect and remove the battery
•
•
to prevent possible leakage.
To purchase a replacement battery, visit our website at www.vtechphones.com
or call (800) 595-9511 . In Canada, go to www.vtechcanada.com or dial
1 (800) 267-7377.
Place the handset in the charger
4.
to charge.
CHARGE light remains
on when charging.
2
Battery charging
Once you have installed the battery, the screen indicates the battery status (see
the table below). For best performance, keep the handset in the telephone base
or charger when not in use. The battery is fully charged after 11 hours of
continuous charging.
Battery indicators Battery status Action
The screen is blank, or
displays Put in charger
and ashes.
The battery has no or very
little charge. The handset
cannot be used.
Charge without interruption
(at least 30 minutes).
The screen displays
Low battery and ashes.
The screen displays
HANDSET X.
The battery has enough
charge to be used for a
short time.
The battery is charged. To keep the battery charged,
Charge without interruption
(about 30 minutes).
place it in the telephone base
or charger when not in use.
Add and register a handset
You can add new handsets (LS6005/LS6005-13/LS6005-15/LS6005-16/LS6005-17,
purchased separately) to your telephone system. Each handset must be registered
with the telephone base before use. Additional handsets registered to the telephone
system are assigned numbers in the sequential order.
When rst purchased and properly charged, each expansion handset alternately
displays To register HS... and ...see manual. The new handset should be charged
without interruption for at least 30 minutes before registering it to the telephone base.
To register a handset:
At the bottom of the telephone base, press and hold
1.
/FIND HANDSET for about four seconds until it
shows Registering...
On the cordless handset, press then it shows
2.
Registering... Both the telephone base and cordless
handset show Registered and you hear a beep when
the registration process completes. The registration
process takes about 60 seconds to complete.
Deregister handsets
If you want to replace a handset or reassign the designated handset number of
a registered handset, you must deregister all handsets and then deregister each
handset individually.
To deregister all handsets:
Press and hold /FIND HANDSET at the bottom of the telephone base for
1.
about 10 seconds until the telephone base shows Registering... then
De-register?
Immediately press /FIND HANDSET again. You hear a conrmation tone.
2.
All handsets alternately show To register HS... and ...see manual. The
3.
deregistration process takes about 10 seconds to complete.
To register the handset(s) to the telephone base again, follow the registration
instructions above.
3
Loading...