VTech CTM-A2315, CTM-A2315-SPK, CTM-A2315-WM Users manual

Analog Contemporary Series
CTM-A2315 | CTM-A2315-SPK | CTM-A2315-WM
Analog Corded Trimstyle Hotel Phone
User‘s Guide
Important safety instructions
When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury, including the following:
1. This product should be installed by a qualified technician.
2. This product should only be connected to the host equipment and never directly to the network such as Public Switch Telephone Network (PSTN) or Plain Old Telephone Services (POTS).
3. Read and understand all instructions.
4. Follow all warnings and instructions marked on the product.
5. Unplug this product from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.
6. Do not use this product near water such as near a bath tub, wash bowl, kitchen sink, laundry tub or swimming pool, or in a wet basement or shower.
7. Do not place this product on an unstable table, shelf, stand or other unstable surfaces.
8. Slots and openings in the back or bottom of the telephone base and handset are provided for ventilation. To protect them from overheating, these openings must not be blocked by placing the product on a soft surface such as a bed, sofa or rug. This product should never be placed near or over a radiator or heat register. This product should not be placed in any area where proper ventilation is not provided.
9. This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply on the premises, consult your dealer or local power company.
10. Do not allow anything to rest on the
power cord. Do not install this product where the cord may be walked on.
11. Never push objects of any kind into this product through the slots in the telephone base or handset because they may touch dangerous voltage points or create a short circuit. Never spill liquid of any kind on the product.
12. To reduce the risk of electric shock, do not disassemble this product, but take it to an authorized service facility. Opening or removing parts of the telephone base or handset other than specified access doors may expose you to dangerous voltages or other risks. Incorrect reassembling can cause electric shock when the product is subsequently used.
13. Do not overload wall outlets and extension cords.
14. Unplug this product from the wall outlet and refer servicing to an authorized service facility under the following conditions:
• When the power supply cord or plug is damaged or frayed.
• If liquid has been spilled onto the product.
• If the product has been exposed to rain or water.
• If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operation instructions. Improper adjustment of other controls may result in damage and often requires extensive work by an authorized technician to restore the product to normal operation.
EN - 2
• If the product has been dropped and the
CAUTIONS
telephone base and/or handset has been damaged.
• If the product exhibits a distinct change in performance.
15. Avoid using a telephone (other than cordless) during an electrical storm. There is a remote risk of electric shock from lightning.
20. In wall mounting position, make sure to mount the telephone base on the wall by aligning the eyelets with the mounting studs of the wall plate. Then slide the telephone base down on both mounting studs until it locks into place. Refer to the full instructions in Installation in the user’s manual.
16. Do not use the telephone to report a gas leak in the vicinity of the leak. Under certain circumstances, a spark may be created when the adapter is plugged into the power outlet, or when the handset is replaced in its cradle. This is a common event associated with the closing of any electrical circuit. The user should not plug the phone into a power outlet, and should not put a charged handset into the cradle, if the phone is located in an environment containing concentrations of flammable or flame-supporting gases, unless there is adequate ventilation. A spark in such an environment could create a fire or explosion. Such environments might include: medical use of oxygen without adequate ventilation; industrial gases (cleaning solvents; gasoline vapors; etc.); a leak of natural gas; etc.
• Keep small metallic objects such as pins and staples away from the handset receiver.
SAVE THESE INSTRUCTIONS
17. Only put the handset of your telephone next to your ear when it is in normal talk mode.
18. The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet.
19. Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal instructions.
EN - 3
Table of contents
Important safety instructions 2
Parts check list 5
Telephone layout 6
Analog Corded Trimstyle 1-line CTM-A2315 6
Analog Corded Trimstyle 1-line CTM-A2315-SPK 7
Analog Corded Trimstyle 1-line
CTM-A2315-WM 9
Installation 10
Analog Corded Trimstyle 1-line CTM-A2315 10
Analog Corded Trimstyle 1-line CTM-A2315-SPK 11
Analog Corded Trimstyle 1-line CTM-A2315-WM 12
Technical specifications 29
Index 30
Telephone settings 14
Analog Corded Trimstyle 1-line CTM-A2315/ CTM-A2315-SPK/ CTM-A2315-WM 14
Telephone operation 16
Analog Corded Trimstyle 1-line CTM-A2315/ CTM-A2315-WM 16
Analog Corded Trimstyle 1-line CTM-A2315-SPK 17
Appendix 18
Troubleshooting 18
VTech Hospitality Limited Warranty Program 21
FCC, ACTA and IC regulations 23
Precautions for users of implanted cardiac pacemakers 26
Operating range 26
Maintenance 27
Disclaimer and Limitation of Liability 27
Mounting bracket footprint dimension 28
EN - 4
Parts check list
Items contained in the respective corded telephone package:
Parts included
Model name
Trimstyle Analog corded 1-Line
Trimstyle Analog corded 1-Line
Model
number
CTM-A2315
CTM-A2315­SPK
Telephone
base with faceplate
and
overlay
Corded handset
or
or
Telephone
line cord
Base
stand
Mounting
bracket
Trimstyle Analog corded 1-Line
CTM-A2315­WM
or
EN - 5
Telephone layout
Analog Corded Trimstyle 1-line CTM-A2315
1 Corded handset earpiece
2 Switch hook 3 VOLUME +/-
4 Numeric dial keys
Speed dial keys
5
6 Microphone
*7
*8
Programmable key #1 Programmable key #2
EMERGENCY/
(Programmable)
MESSAGES
(Programmable)
MESSAGES
(Programmable)
EMERGENCY/
(Programmable)
*Design is subject to change without prior notice.
1 MESSAGE WAITING LED
2 Wall mount clip
3 Faceplate and overlay
4 Ringer tone switch
5 Voicemail voltage detection
6 Telephone line jack
7 Coiled handset cord jack
8 Grooves for base stand
EN - 6
Analog Corded Trimstyle 1-line CTM-A2315-SPK
1 Corded handset earpiece
2 Switch hook 3 VOLUME +/-
4 Numeric dial keys
5
6
7 Microphone
*8
9 MUTE
*10
11 Speakerphone
/SPEAKER Speed dial keys Programmable key #1 Programmable key #2
EMERGENCY/
(Programmable)
MESSAGES
(Programmable)
MESSAGES
(Programmable)
EMERGENCY/
(Programmable)
*Design is subject to change without prior notice.
EN - 7
1 MESSAGE WAITING LED
2 Wall mount clip
3 Faceplate and overlay
4 Ringer tone switch
5 Voicemail voltage detection
6 Telephone line jack
7 Coiled handset cord jack
8 Grooves for base stand
EN - 8
Analog Corded Trimstyle 1-line
CTM-A2315-WM
1 Corded handset earpiece
2 Switch hook 3 VOLUME +/-
4 Numeric dial keys
Speed dial keys
5
6 Microphone
*7
*8
Programmable key #1 Programmable key #2
EMERGENCY/
(Programmable)
MESSAGES
(Programmable)
MESSAGES
(Programmable)
EMERGENCY/
(Programmable)
*Design is subject to change without prior notice.
1 MESSAGE WAITING LED
2 Wall mount clip
3 Faceplate and overlay
4 Grooves for mounting bracket
5 Ringer tone switch
6 Voicemail voltage detection
7 Telephone line jack
8 Coiled handset cord jack
EN - 9
Installation
Analog Corded Trimstyle 1-line CTM-A2315
Telephone base installation
Installation option - desktop position
1. Turn the telephone base over with the bottom side facing up. Insert the base stand into the lower grooves on the telephone base until they lock securely as shown below.
2. Connect both the telephone line and coiled handset cord to the telephone base and route them along the wire ducts accordingly. Install the telephone base as shown below.
Telephone If you have High Speed Internet Access service, a DSL filter (not included) is required.
Telephone line cord
Telephone line jack
wall jack
Coiled handset cord jack
EN - 10
Loading...
+ 21 hidden pages