V-TAC Innovative Led Lighting Instruction Manual
Installation
Installation A: Wall Mounted
1
1. Prepare lamp, accessories and tools well firstly.
2. Insert the L-shaped bracket into the socket. (Figure 1)
3. Use allen wrench to tighten the cap screws. (Figure 2)
4. According to demanded installation height, drill 2 holes of φ8mm with a
depth of at least 60mm on the wall, and fix the expansion screws into the
holes. Then use a wrench to fix the light fixture. (Figure 3)
Installation B: Lamp-post Mounted
32
Installation
Height: 3-5m
1 2
1. Prepare lamp, accessories and tools well firstly.
2. Open the cover of lamp socket. (Figure 1)
3. Fix the lamp-post fixture onto the lamp socket (do not lock first). (Figure 2)
4. Set up the lamp onto the lamp-post. (Figure 3)
5. Adjust the lamp parallelly and lock the lamp-post fixture. (Figure 4)
52mm
Depth of
Holing: 60mm
3
Ă40-Ă50mm
4
Warning!
15W/1600LM
1. The lamp is equipped with an internal battery pack, which is replaceable.
If any need, please contact seller for correct new battery pack.
2. Non-professionals please do not disassemble the lamp.
3. Please do not dispose the battery with household garbage to avoid explosion.
Model：VT-ST15
Please read and follow all instructions to operate.
Save this manual for future reference.
Specification
Working Mode
8548/8549SKU
Power/Lumen 15W / 1600LM
LEDs SMD2835*40PCS
Li-ion Battery Pack
Solar Panel 9.5Wp, Poly Crystalline Silicon
IP Degree IP65 waterproof
Beam Angle 140X70-TPIII
Detection Angle/Area 120°/ 3-8Mtrs
Dimension 413*232*58MM
Installation Height
Lifespan 35,000hrs
18650/7.4V/10800mAh, replaceable
3-5Mtr
Features
Solar Powered
Light on/off Automatically
Safe
Battery Replaceable
Multi Functional
ZERO Electricity Cost
PlR Inductive
IP65 Waterproof
Cordless
Long Lasting
Smart button:
ON/OFF
This lamp is with auto-adjusting working
mode, you only need to press the
button once, it will work permanently.
First 5Hrs lighting:
Automatically turns on to full brightness
(1600lm) when motion is detected in the
range ≤ 8mtrs and then turns to 3%
brightness in 20 seconds of no motion.
After 5Hrs lighting or When battery capacity below 30%:
5 minutes later
Automatically turns on to full brightness(1600lm) when motion is detected in the range ≤ 8mtrs
and then turns to 3% brightness in 20 seconds of no motion, then turns off after 5 minutes.
Notice
1. This is a solar powered lamp, please install it in a location where can
get enough sunshine.
2. Please note the lighting time depends on sunshine duration & weather.
3. Built-in intelligent IC with over-charge, over-discharge and over-voltage
protection.
4. The lamp will light up automatically at dusk.
Applications
* This lamp can be used as wall light and street light, multi-funcational.
* You can easily install it in garden, garage, pathway, street, entrance, courtyard,
square etc.
Loading...