Vortex Optics CROSSFIRE II 2-7X32 RIFLESCOPE User Manual
CrossFireIICrossFire
CrossFireII
CrossFireII
RIFLESCOPE
RIFLESCOPE MANUAL
1-Inch Diameter Main Tube
RIFLESCOPE
CrossFireII
RIFLESCOPE
The Vortex ® Crossfi re II ® Rifl escopes
Specifically designed for discriminating hunters and shooters, the
®
Crossfire II
and reliability. With features such as generous long eye relief, rugged
construction and precise, smooth controls, the Crossfire II riflescopes are
ready for any situation.
series of riflescopes offer the highest levels of performance
Dual Use: Shooting Tactical / Hunting
Fast Focus Eyepiece
Reticle Focus
Magnifi cation
Adjustment Ring
Elevation
Adjustment Knob
Windage
Adjustment Knob
Adjustable Objective
(Select models)
Objective
Lens
Illumination
Adjustment Knob
(Select models)
2
3
CrossFireIICrossFire
RIFLESCOPE
RIFLESCOPE A DJUSTMENTS
Reticle Focus
Vortex Crossfire II riflescopes use a fast focus eyepiece designed to quickly
and easily adjust the focus on the riflescope’s reticle.
To adjust the reticle focus:
• Look through the riflescope at a blank
white wall or up at the sky.
• Turn the eyepiece focus knob in or out
until the reticle image is as crisp as possible.
• Note: Try to make this particular
adjustment quickly, as the eye will try to compensate for an out-of-focus
reticle.
Once this adjustment is complete, it will not be necessary to re-focus every
time you use the riflescope. However, because your eyesight may change
over time, you should re-check this adjustment periodically.
Variable Power Adjustments
To change magnifications, turn
the magnification ring to the
desired level.
Warning
Looking directly at the sun through a
riflescope, or any optical instrument, can
cause severe and permanent damage to
your eyesight.
Adjust the reticle focus
Magnifi cation
Scale
Windage and Elevation Adjustments
The Crossfire II riflescope incorporates adjustable elevation and windage
dials with audible clicks. Each audible click moves the bullet’s point-of-
impact 1/4 of a minute of angle (MOA).
1/4 MOA closely corresponds to 1/4 inch at 100 yards, 1/2 inch at 200
yards, 3/4 inch at 300 yards...taking four (4) clicks to move the bullet’s
point-of-impact approximately one inch at 100 yards.
How to adjust windage and elevation settings
Begin adjusting the windage and elevation settings by first removing
the outer covers. Then, move the
turrets in the direction you wish the
bullet’s point-of-impact to change.
To make the adjustments, rotate the
adjustment dial in the appropriate
direction (up/down or left/right) as
indicated by the arrows.
After sight-in, you can re-align the
zero marks on the turret dials with
the reference dots if you wish (see
Resetting Adjustment Dials with Zero
Reset on page 12). Replace outer
covers when done.
To adjust settings, turn dials:
· Up / Down
· Left / Right
4
5
Loading...