Vollrath 40826 Installation Manual
The Vollrath Company, L.L.C.
1236 North 18
P.O. Box 611
Sheboygan, WI 53082-061
th
Street
Operating and Safety
Instructions
Food Processor
Model Number:
40826, Food Processor, 3 QT
2500114-A
2
FOOD PROCESSOR
Food Processor
Thank you for purchasing this Vollrath Food Processor. Before operating this unit, read
and familiarize yourself with the following operating and safety instructions. SAVE
THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING
RISK OF INJURY
Severe injury can occur if this equipment is not used properly.
To reduce risk of injury:
• Keep out of reach of children
• Do not turn unit on unless all guards are in place
• Units must be connected to a properly grounded electrical supply matching the
nameplate rating.
• Always unplug unit before cleaning
• Keep unit away from water; avoid water jets during cleaning
• Unit should only be used in a flat, level position
• Do not operate unattended
• Do not operate this appliance with a damaged cord or plug.
• If you experience any problems with your appliance, unplug it immediately from
the electrical outlet.
• The use of accessories or attachments, not recommended or sold by The
Vollrath Company may cause fire, electric shock or injury to persons.
Function and Purpose:
This unit is intended to be used for horizontal cutting, chopping, and mixing in
commercial foodservice operations only. It is not intended for household use. It is not
intended to be used with boned meat and frozen food.
Installation and assembly of the Food Processor:
1. Remove all packing material and tape as well as any protective plastic from the
unit.
2. Remove the bowl and cutter assembly and clean thoroughly.
3. Clean any glue residue left over from the plastic or tape.
4. Replace the bowl making sure pin on the bowl assembly is inserted into the
guide plate on base of processor.
5. Replace cutter assembly by aligning cross-pin in cutter blade with slot in drive
shaft.
6. Replace the cover by aligning pins in back of cover with holes in base.
7. Place the unit in the desired location and verify stability. The working area must
be dry, away from potential heating sources, and away from passageways.
8. Plug the unit into a properly grounded electrical supply matching the nameplate
rating. Damage to the unit can occur if incorrect power is supplied to unit.
NOTE: If cover will not seat on top of bowl, make sure cutter assembly pin is
positioned properly onto motor shaft.
2500114-A
Loading...