Vivotek AW-IHU-0600 Installation Guide

AW-IHU-0600 Industrial UPoE Switch

Quick Installation Guide

INTRODUCTION

The AW-IHU-0600 is a rugged media PoE switch designed for delivering a max. of 60 watts to powered devices. The ber
uplink port can be used to extend the connection to a remote site. With its multi-purpose design, it is t for IP surveillance,
trafc monitoring, and security applications in critical environments. The machine features a total budget of 240 watts and
a wide range of operating temperatures ranging from -40°C to 75°C.

PACKAGE CONTENTS

* 1x PoE switch * 1x Quick Installation Guide * 1x 6-pin terminal block
* 2x wall mount brackets * 1x DIN rail bracket

IMPORTANT:

1. Install the switch in a ventilated and dry place that is free of electromagnetic source, vibration, moisture, and dust.

2. Make sure the ventilation openings on the switch are not blocked.

3. Use ber optic cables and transceiver compliant with the following: Multi-mode: 50/125um, 62.5/125um, 850nm;
Single-mode): 9/125um ,1310nm.

4. DC input: 50V~56VDC. Follow the printed polarity for V+, V-, and Ground.

CONNECTION

1. Pull out the 6-pin terminal block.

2. Connect positive wires to V+, negative wires to V-, and

neutral wire to the ground screw.

Connect the 24V DC @1A pins to external devices.

When 2 power pins are connected, the relay is shorted.
When any of them is diconnected, the relay connection
is open.

3. Connect SFP transceivers and ber cables to the ber

ports.

4. Install the 6-pin terminal block.

WARNING - Always ground the power source to maintain a clean power input.

- Always shut off power source before connecting power wires.

no use 1000M

1 2

ON

100M

100~240 VAC IN

50~56VDC IN

IMPORTANT -
Note that the conguration change only takes effect after a power cycle.

DIP 2 1000M The F5/F6 port in the Gigabit mode (default)

100M The F5/F6 ber port in the 100Mbit mode.

LED DEFINITIONS

PW1 ON When power is connected.
PW2 ON When power is connected.
ERR (relay) OFF When both PW1 and PW2 are

connected.

ON Only PW1 or PW2 is connected.

F5 ON Port 5 ber is detected.

OFF Port 5 ber is not detected.
Flashing Data is being transmitted or received.

F6 ON Port 6 ber is detected.

OFF Port 6 ber is not detected.
Flashing Data is being transmitted or received.

Link ON TX link is detected.

OFF Link is not detected.
Flashing Port is active.

SPD ON 1000M speed is detected.

OFF 10/100M speed is detected.

PoE1~4 ON PD is detected on the designated port.

OFF No PD is detected.