IP Surveillance
AP-GIC-015B-095
Surveillance PoE Junction Box
Installation Guide
Rev.: 1.0
CAUTION:
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
UNPACKING:
Unpack carefully. Electronic components can be damaged if improperly handled or
dropped. If an item appears damaged in shipment, place it properly in its carton and
notify the shipper.
IMPORTANT!:
1. The electrical connections and conduit installations shall be made by a certied electrician following
local regulations.
2. Risks of electric shock exist. The mains supply shall be disconnected before installation.
3. Read and follow Instructions: All operating and user instructions should be read and followed before
the unit is to be operated.
4. This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
the protective device is listed rated not greater than 20A.
5. Attach the ground wire (to external ground) to a suitable grounding point, e.g., an earth stake.
6. Observe national and local regulations for the installation.
7. To avoid additional accummulation of moisture, please avoid installing the components in cabinet
during a raining weather.
8. Only use applicable tools when installing this product; excessive force can damage the product.
9. Use only accessories compliant with the technical specications of the product.
10. When the need arises for transportting this product, it is recommended to use the original shipping
package.
Revision History:
Rev. 1.0: Initial release.
Mechanical Dimensions:
2
Applicable Mount & Brackets
I
Item Models Applicable Cameras
Junction box AP-GIC-015B-095 SD9365, SD9366, SD9363, SD9364
External
housings
II
Route your power wires through a 3/4" conduit into the power box. The wiring scheme is shown below.
The power supply converts 100~240V power to the 95W PoE output to IP cameras.
AE-239, AE-244, AE-23E, AE-23F Box cameras
Wiring
English
Neutral
100~240V Line IN
for Ethernet
cables
Ground
Ground
to camera
for power
wires
from
network
3
Introduction
III
The power box can be mounted with the AM-314, AM315 pole-mount, AM-414 corner-mount bracket, or
directly secured to a wall.
The power box can be mounted with the external housings, such as the AE-239, AE-244, AE-23E, and
AE-23F.
4
Installation
IV
Use the included M10 hex socket screws to secure the power box to a pole-mount or corner mount
bracket.
M10
AM-314
AM-315
AM-414
3/4” conduit
The mounting hole denition is illustrated below. The same mounting hole pattern apply to all pole-
mount and corner-mount brackets.
For this PoE
juncon box
Pole-mount bracket
English
Pole-mount bracket Corner-mount bracket
5
If the power box is directly mounted to wall, drill holes in a diameter of 9.5mm or 3/8", and 4cm deep.
M8
Use the following mounting positions for the camera housings (via AM-21D and AM-21E brackets).
AM-21D
AM-21E
6
This page is intentionally left blank.
English
7
This page is intentionally left blank.
8
Loading...