Vivo MOUNT-VW03G Instruction Manual

Gas Spring TV Wall Mount

Scan the QR code with your mobile device or follow the link

for helpful videos and specications related to this product.

Instruction Manual

https://vivo-us.com/products/mount-vw03g

[e-mail] www.vivo-us.com 1-800-371-5654

SKU: MOUNT-VW03G

2 3

ASSEMBLY STEPS

STEP 1

Remove VESA plate from the mount (A) by removing two bottom nuts with wrench (H) and loosening

top two nuts. The plate will li out from the slots on the top of the bracket.

PACKAGE CONTENTS

TOOLS NEEDED

17 - 66 lbs

(8 -30 kg)

DO NOT EXCEED WEIGHT CAPACITY.

Failure to do so may result in serious injury.

WARNING!

Phillips

Screwdriver

B (x2)

Cover

M-F (x4)

D5 Washer

M-G (x4)

D8 Washer

M-H (x8)

Small

Spacer

W-A (x6)

Bolt

M-E (x4)

M8x50

M-A (x4)

M5x14

M-B (x4)

M6x14

M-C (x4)

M8x20

M-D (x4)

M6x30

If you do not understand these directions, or if you have any doubts about the safety of the

installation, please call a qualied technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specied in this manual. Do not exceed weight capacity.

We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or

inappropriate use.

NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED

W-C (x6)

Washer

W-B (x6)

Anchor

Drill

CAUTION!

DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR WALL CONSTRUCTION. USE WOOD STUDS TO
MOUNT. We include mounting for brick and concrete walls. If unsure, please contact us at vivo-us.
com, email at [e-mail], or call us at 1-800-371-5654.

F (x1)

Allen Wrench

G (x1)

Allen Wrench

I (x1)

Bubble Level

M-I (x8)

Big

Spacer

A (x1)

Mount

C (x8)

Bolt

D (x2)

VESA Ada pter

E (x2)

VESA Ada pter

H (x1)

Wrench

STEP 2

OPTION A: Wood Wall

Use mount (A) to mark mounting holes on wall where stud is located. Using a 3/16” drill bit, drill
holes at least 2.2” deep into marked locations. Insert bolt (W-A) into top hole, leaving 3mm of thread
exposed. Hang top hole in mount over the bolt, and secure using two more bolts (W-A) with washers

(W-C). Tighten all bolts.

Pencil

NOTE: Do not use concrete anchors

(W-B) with wood studs.