Viking MVWD630SS Installation Manual
Installation
GUIDE
6 SERIES
Warming Drawer
MVWD630 / CMVWD630
1
Table of Contents
Important Safety Instructions __________________________________________________________________________ 2
Dimensions _________________________________________________________________________________________ 3
Speci cations _______________________________________________________________________________________ 4
Cutout Dimensions___________________________________________________________________________________ 4
Electrical Requirements _______________________________________________________________________________ 5
General Information __________________________________________________________________________________ 5
Installation _________________________________________________________________________________________ 6
Final Preparation ____________________________________________________________________________________ 7
Service & Registration ________________________________________________________________________________ 7
Important Safety Instructions– Read and Follow!
Before beginning, please read these instructions completely and carefully.
WARNING
If the information in this manual is not followed exactly, a re or explosion
may result causing property damage, personal injury or death.
DANGER
Hazards or unsafe practices which WILL result in
severe personal injury or death
WARNING
Hazards or unsafe practices which COULD result in death
or severe personal injury
CAUTION
Hazards or unsafe practices which COULD result in minor
personal injury.
All safety messages will identify the hazard, tell you how
to reduce the chance of injury, and tell you what can happen
if the instructions are not followed.
WARNING
To reduce the risk of re, electric shock, or injury to persons,
installation work and electrical wiring must be done by
quali ed people in accordance with all applicable codes and
standards, including re-rated conditions.
WARNING
• DO NOT remove permanently a xed labels,
warnings, or plates from product. This may void the
warranty.
• All local and national codes and ordinances must
be observed. Installation must conform with local
codes, or in the absence of codes, the National
Electrical Code, ANSI/NFPA-70 – latest edition.
• The installer must leave these instructions with the
consumer who should retain for local inspector’s use
and for future reference.
In Canada: Installation must be in accordance with
the current CSA C22.1 Canadian Electrical Codes Part
1 and/or local codes.
WARNING
ELECTRICAL SHOCK HAZARD
This appliance is equipped with a 3-prong power
cord with a grounding plug for your protection
against shock hazard and should be plugged
directly into a properly grounded receptacle.
Only use power cord supplied with the unit.
To prevent possible damage to cabinets and cabinet
fi nishes, use only materials and fi nishes that will not
discolor or delaminate and will withstand temperatures up
to 194°F (90°C). Heat resistant adhesive must be used
if the product is to be installed in laminated cabinetry.
Check with your builder or cabinet supplier to make sure
that the materials meet these requirements.
2
Dimensions
Side View
10-3/4”
(27.3 cm)
29-3/4”
(75.6 cm)
25-3/4”
(65.4 cm)
22-1/2”
(57.1 cm)
25-1/4”
(64.1 cm)
1”
(2.5 cm)
21-1/4”
(54.0 cm)
Rear View
2” (5.1 cm)
3”
(7.6 cm)
2-1/4”
(5.7 cm)
22-1/2”
(57.2 cm)
120 VAC Electrical
Connection
27-3/4”
(70.5 cm)
21-1/4”
(54.0 cm)
(22.9 cm)
WARNING
ELECTRICAL SHOCK HAZARD
This appliance is equipped with a 3-prong power cord
with a grounding plug for your protection against shock
hazard and should be plugged directly into a properly grounded
receptacle. Only use power cord supplied with the unit.
3
9”
Loading...