Viking P30FTDSS, P30FTSSS Installation Manual

Viking Installation Guide

Viking Range Corporation

111 Front Street

Greenwood, Mississippi 38930 USA

[phone]

For product information,

call 1-888-VIKING1 (845-4641)

or visit the Viking Web site at

vikingrange.com

F20701A EN

Professional & Designer Oven Accessory

Flush Mount Kit

(040711)

Removing Existing Trim

Remove the existing side trim pieces from the oven. There should be one trim piece on each
side of the oven.

Removing Existing Trim

For Professional ovens, there will be a trim piece at the top and bottom of the oven that will
need to be removed. Also, on the Professional ovens, the door will need to be removed prior
to removing the lower vent trim and putting on the new trim.

NOTE: Keep the screws that are left after removing the existing side trim pieces. These
screws will be used to install the flush mount accessory trim pieces.

VESO

Single Oven

DDOE

Double Oven

2 3

Installing Flush Mount Trim

After removing the existing side pieces, install the flush mount trim pieces to the oven.

1. Remove the protective plastic from the flush mount trim pieces.

2. Install the two flush mount trim pieces to the oven (see diagram).

3. For Professional ovens, install the top and bottom trim pieces (see diagram).

NOTE: Only Professional model ovens will require a top and bottom flush mount trim
piece.

NOTE: There will be a designated right and left hand side flush mount trim piece. Install
the corresponding trim piece on the correct side, as they are not interchangeable.

4. After installing the flush mount trim pieces, the oven can be installed in the cutout.

VESO

Single Oven

Installing Flush Mount Trim

DDOE

Double Oven

54

76