Viking MVFI7240WRSS, MVRI7240WLSS, VRI7240WRWH, MVFI7180WRSS Installation Manual

Installation

Guide

7 SERIES

Integrated All Refrigerator

VRI7240 / CVRI7240

FRI7240 / CFRI7240

MVRI7240 / CMVRI7240

Integrated All Freezer

VFI7180 / CVFI7180/ VFI7240 / CVFI7240 FFI7180 / CFFI7180 / FFI7240 / CFFI7240

MVFI7180 / CMVFI7180 / MVFI7240 / CMVFI7240

Table of Contents

Warnings and Important Information ________________________________________________________________________________ 3

Cutout Dimensions___________________________________________________________________________________________ 5

Speci cations _______________________________________________________________________________________________ 6

Dimensions ________________________________________________________________________________________________ 8

Tipping Radius ______________________________________________________________________________________________ 9

Anti-Tip Dimensions ________________________________________________________________________________________ 10

General Information

Electrical Requirements ______________________________________________________________________________________ 11

Water Requirements _________________________________________________________________________________________ 12

Unpacking & Moving ________________________________________________________________________________________ 13

Installation

Custom Front Panel Dimensions _______________________________________________________________________________ 14

Custom Front Panel Install ____________________________________________________________________________________ 15

Water Line Installation _______________________________________________________________________________________ 16

Leveling Unit _______________________________________________________________________________________________ 17

Kickplate Installation _______________________________________________________________________________________ 18

Flush Mount Side Trim _______________________________________________________________________________________ 19

Door Panel Adjustments _____________________________________________________________________________________ 19

Door Stop Adjustment _______________________________________________________________________________________ 20

System Speci cations and Data ________________________________________________________________________________ 21

Performance Checklist ___________________________________________________________________________________________ 22

Control Panels __________________________________________________________________________________________________ 22

Service & Registration ___________________________________________________________________________________________ 23

IMPORTANT – Please Read and Follow!

• Make sure that incoming voltage is the same as unit rating. An electric rating plate specifying voltage, frequency, wattage, amperage, and phase is attached to the product.

• To reduce the risk of  re, electrical shock, or injury to persons, installation work and electrical wiring must be done by a quali ed technician in accordance with all applicable codes and standards, including  re-rated construction.

• The installer should leave these instructions with the consumer who should retain them for local inspector’s use and for future reference.

For additional information or installation videos, visit our website at www.vikingrange.com

Your safety and the safety of others is very important.

We have provided many important safety messages in this manual and on your appliance. ALWAYS read and obey all safety messages.

This is the safety alert symbol. This symbol alerts you to hazards that can kill or hurt you and others.

All safety messages will be preceded by the safety alert symbol and the word “DANGER” or “WARNING.” These words mean:

DANGER

You will be killed or seriously injured if you

don't follow instructions.

WARNING

You can be killed or seriously injured if you

don't follow instructions.

hazard, tell you how to reduce the chance

of injury, and tell you what can happen if

It is your responsibility to:

• comply with installation speci cations and dimensions.

• properly install unit.

• remove any moldings or decorative panels that prevent the unit from being serviced.

• make sure that you have these materials (not provided with your unit), which are necessary

for proper installation:

• 1/4” (6 mm) copper tubing with shuto valve

• 1– Saddle valve (do not use self-piercing feature of the valve)

• assure that  oor will support unit, door panels and contents (approximately

1200 pounds [540 kg]).

• provide a properly grounded electrical outlet.

• assure that location will permit appliance doors to open 90º minimum.

Required tools

• Drill

• Drill bits - 3" Phillips (Ph2), Torx (T15 & T20), 1/4" and 5/16" hex drive

• Rubber mallet

• 3/8" wrench

All safety messages will identify the

the instructions are not followed.

IMPORTANT – Please Read and Follow!

A GFI shall be used if required by NFPA-70 (National Electric Code), federal/state/local laws, or local ordinances.

• The required use of a GFI is normally related to the location of a receptacle with respect to any signi cant sources of water or moisture.

• Viking Range, LLC will requirements below.

If the use of a GFI is required, it should be:

• Of the receptacle type (breaker type or portable type

• Used with permanent wiring only (temporary or portable wiring

• On a dedicated circuit (no other receptacles, switches or loads in the circuit)

• Connected to a standard breaker of appropriate size (GFI breaker of the same size

• Rated for Class A (5 mA +/- 1 mA trip current) as per UL 943 standard)

• In good condition and free from any loose- tting gaskets (if applicable in outdoor situations)

• Protected from moisture (water, steam, high humidity) as much as reasonably possible

NOT warranty any problems resulting from GFI outlets which are not installed properly or do not meet the

NOT recommended)

WARNING

ELECTRICAL SHOCK HAZARD Disconnect power or turn power disconnect switch to OFF position before removing top grille.

Failure to do so can result in death or electrical shock.

Power On/O Switch

Your unit is shipped with the power switch on. When  rst plugged in, the display will  ash. Push any button to initiate display.

The power on/o switch is located to the left of the center behind the header panel. It is used to turn the power o when cleaning or servicing the refrigerator.

To turn the power o , remove the header panel by using a small  at head screwdriver to pry between the breaker frame and the header panel on the side closest to the hinge (see drawing A). There is a small pocket cut into the bottom of the header panel at that location for that purpose. Once you have pulled the header panel away from the unit (drawing B) enough to get your  ngers behind it slowly pull the opposite side away from the unit.

NOTE: There are wires connected to the backside of the header panel for the Viking light and the WiFi board on the back of the light.

WARNING

TIP OVER HAZARD Appliance is top heavy and tips easily when not completely installed. Keep doors closed until appliance is completely installed and secured per installation instructions.

Use two or more people to move and install appliance. Failure to do so can result in death or serious injury.

power switch

To turn power on, press power on/o switch to the on position. Replace header panel. IMPORTANT: Be sure the power on/o switch is in the on position after cleaning or servicing.

Cutout Dimensions

25”

(63.5 cm)

84”

(213.4 cm) min.

opening height

85-3/16”

(216.3cm) max.

opening height

Can be located on either side

Electric Outlet Location

15-1/2”

(39.4 cm)

4-1/4”

(10.8 cm)

leveling

dimension

Water Line Entry Area

*Refer to Specfication

chart for

specific Models

*Note: For all models, 3” back from the front of the cabinet on both sides needs to ﬁ nished like the outside of the cabinets

5/8”

(1.6 cm)

1/2”

(1.3 cm)

*Cutout

Width

6”

(15.2 cm)

3”

(7.6 cm)

Speci cations (VRI/FRI/MVRI)

Integrated All Refrigerator

Description VRI MVRI

Overall width 24" (61.0 cm) 24" (61.0 cm)

Overall height (from bottom) 83-15/16" (213.2 cm) min to 84-3/4" (215.7 cm) max

Overall depth from rear To front edge kickplate: 22-1/16” (56.0 cm)

Cutout width 24" (61.0 cm) 24" (61.0 cm)

Cutout height 84" (213.4 cm) min to 85-3/16" (216.3 cm) max

Cutout depth 25” (63.5 cm) min.

Electrical requirements 115 volt, 60 Hz, 15 amp dedicated circuit; 3-wire cord with

Maximum amp usage 9.9 amps

Inlet water requirements 1/4” copper tubing inlet waterline; minimum 20 psi;

Overall interior capacity Refrigerator

24" 24"

To front of door panel: 24-3/4” (62.9 cm)

To front of handle endcap:

27-11/16" (70.3 cm)

grounded 3-prong plug attached to product

maximum 120 psi

12.9 cu. ft.

(366.9 liters)

To front of handle endcap:

27-5/16" (69.4 cm)

12.9 cu. ft.

(366.9 liters)

Approximate shipping weight 450 lbs. (202.5 kg)

Integrated All Refrigerator w/Custom Panel

Description FRI - 24"

Overall width 24" (61.0 cm)

Overall height (from bottom) 83-15/16" (213.2 cm) min to 84-3/4" (215.7 cm) max

Overall depth from rear To front edge kickplate: 22-1/16” (56.0 cm)

To front of door panel: 24” (61.0 cm)

Cutout width 24" (61.0 cm)

Cutout height 84" (213.4 cm) min to 85-3/16" (216.3 cm) max

Cutout depth 25” (63.5 cm) min.

Electrical requirements 115 volt, 60 Hz, 15 amp dedicated circuit; 3-wire cord with

grounded 3-prong plug attached to product

Maximum amp usage 9.9 amps

Inlet water requirements 1/4” copper tubing inlet waterline; minimum 20 psi;

maximum 120 psi

Overall interior capacity Refrigerator 12.9 cu. ft. (366.9 liters)

Approximate shipping weight 450 lbs. (202.5 kg)

Speci cations ( VFI/FFI/MVFI)

Integrated All Freezer

Description VFI MVFI

Overall width 18" (45.7 cm) 24" (61.0 cm) 18" (45.7 cm) 24" (61.0 cm)

Overall height (from bottom) 83-15/16" (213.2 cm) min to 84-3/4" (215.7 cm) max

Overall depth from rear To front edge kickplate: 22-1/16” (56.0 cm)

Cutout width 18" (45.7 cm) 24" (61.0 cm) 18" (45.7 cm) 24" (61.0 cm)

Cutout height 84" (213.4 cm) min to 85-3/16" (216.3 cm) max

Cutout depth 25” (63.5 cm) min.

Electrical requirements 115 volt, 60 Hz, 15 amp dedicated circuit; 3-wire cord with

Maximum amp usage 9.9 amps

Inlet water requirements 1/4” copper tubing inlet waterline; minimum 20 psi;

Overall interior capacity Freezer

Approximate shipping weight 450 lbs. (202.5 kg)

(238.9 liters)

18" 24" 18" 24"

To front of door panel: 24” (61.0 cm)

To front of handle endcap:

27-11/16" (70.3 cm)

grounded 3-prong plug attached to product

8.4 cu. ft.

12.2 cu. ft.

(361.2 liters)

maximum 120 psi

To front of handle endcap:

27-5/16" (69.4 cm)

8.4 cu. ft.

(238.9 liters)

(361.2 liters)

12.2 cu. ft.

Integrated All Freezer W/Custom Panel

Description FFI

18" 24"

Overall width 18" (45.7 cm) 24" (61.0 cm)

Overall height (from bottom) 83-15/16" (213.2 cm) min to 84-3/4" (215.7 cm) max

Overall depth from rear To front edge kickplate: 22-1/16” (56.0 cm)

To front of door panel: 24” (61.0 cm)

Cutout width 18" (45.7 cm) 24" (61.0 cm)

Cutout height 84" (213.4 cm) min to 85-3/16" (216.3 cm) max

Cutout depth 25” (63.5 cm) min.

Electrical requirements 115 volt, 60 Hz, 15 amp dedicated circuit; 3-wire cord with

grounded 3-prong plug attached to product

Maximum amp usage 9.9 amps

Inlet water requirements 1/4” copper tubing inlet waterline; minimum 20 psi;

maximum 120 psi

Overall interior dimensions Freezer

Approximate shipping weight 565 lbs. (254.3 kg)

8.4 cu. ft.

(238.9 liters)

12.2 cu. ft.

(361.2 liters)

Dimensions (VRI/FRI/MVRI)

83-15/16”

(213.2 cm)

22-1/16”

(56.0 cm)

Model Dimension A Dimension B*

VRIVFI

FRI/FFI

MVRI/MVFI

4-1/16”

(10.3 cm)

27-11/16" (70.3 cm) 24-3/4" (62.9 cm)

N/A 24" (61.0 cm)

27-5/16" (69.4 cm) 24-3/4" (62.9 cm)

*To outside of door panel

+ 16 hidden pages