Viking BQC5541SS, BQC5421SS Installation Manual

Use/Installation Guide

5 Series

Outdoor Gas Grill Carts

2

IMPORTANT: PLEASE READ AND FOLLOW

1. Before beginning, please read these instructions completely and carefully.

2. Do not remove permanently affixed labels, warnings, or plates from product.

BEFORE INSTALLING GRILL TO CART: Remove drip tray, grill grates, flavor grids, and warming racks
from the grill.

To remove side shelves (optional):

The side shelves on the cart can be removed if needed. This must be done before installing the grill on the cart.
With the shelf in the up position, remove the screws in the shelf support bracket. This will allow you to remove both
the brackets and the shelf.

To mount grill to cart for 30” and 36”:

Always wear gloves when handling the gas grill. Although the grill is deburred prior to shipment, some edges may
still be sharp enough to cause injury during handling. With a minimum of two (2) people, place the grill in the cart with
about 3 to 4 inches hanging out the front making sure that the male fitting on the bottom of the grill is inside the cart.
Push the grill back until the front sides of the cart are flush with the back of the landing ledge on the grill.
Be careful: the grill unit is very heavy!

To mount grill to cart for 42” and 54”:

With side panels removed from cart, place grill inside the cart and push the grill back until it hits the back wall. Slide on side
panels from the rear to fit slots onto shoulder screws.

3

Attaching the grill to the cart

Once the grill has been mounted on
the cart, the back of the landing ledge should
be flush with the front sides of the cart. The
5/8” (1.6 cm) hole on the top front corners of
the cart should be aligned with the receiving
holes in the grill heat shields. If your grill does
not have the receiving holes in the heat
shield, you will need to drill them out with a
9/64” (.14 cm) drill bit. With the grill and cart
mounted together, place the drill bit in the 5/8
hole and center in the 1/4”x3/8” slot. Drill
through the heat shield. Take the #10X3/4”
(1.9 cm) sheet metal screws (A) supplied with
the cart and attach the cart sides to the grill.
After securing the grill to
the cart, snap the hole covers (B) supplied
with the cart into the 5/8” (1.6 cm) holes in
the cart corners.

5/8” (1.6 cm) dia. hole

(A) #10 x 3/4” (1.9 cm)

sheet metal screw

(B) 5/8” (1.6 cm) hole

Support
bracket
screws

Shelf
adjustment
screw

Supports

Front View

Leveling the Side Shelves

To level the side shelves, lift the shelf so that the
shelf adjustment screw is visible between the two
supports on the shelf brackets. Turn the screw
with a 3/32” (.2 cm) allen wrench counter clockwise to raise
the shelf and clockwise to lower the shelf (3/32” allen
wrench supplied with cart).

4

Cart Door Adjustment

The cart doors come adjusted from the factory. Depending on how level the surface the cart is being placed on, the
door(s) may need to be adjusted after the grill is assembled on the cart.

There are two adjustment screws on the hinge receiver.

1) The front screw is used to center the door in the opening. Turning the front screws in or out will center the door in the frame.

2) The back screw is used to align the front of the door with the cart frame and secure the door to the cart. Slightly loosen the
screw and slide the door in or out. Retighten the screw to secure the door.

Back Screw

Front Screw

Door Hinge

(2 places)