Vestil P-CADDY User Manual

REV.

ZONE

1. Place Pallet Caddy on pallet truck with front lip of caddy sitting in front of the pallet truck carriage and square caddy to pallet truck.

2. With marker, mark on the bottom side of the caddy the two drill points. Place the J-bolts as far toward the forks as possible for better stability.

3. Remove the caddy and using a 1/4" drill bit, drill the two holes marked in step two.

4. Set the caddy back in place and insert the j-hooks.

REVISIONS

DESCRIPTION

DATE

APPROVED

5. Install the washers over the threaded portion of the J-hook on the inside of the caddy and install the nuts. Tighten until snug. Make sure unit is level to pallet jack when done.

6. Add self drilling screws(included) as nessesary taking care not to damage parts on the pallet jack

PROPRIETARY AND CONFIDENTIAL

THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF VESTIL MANUFACTURING CO. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF VESTIL MANUFACTURING CO. IS PROHIBITED.

Hardware List Qty (2) 1/4" x 4" J-Bolt (2) 1/4" Lock nuts (2) 12-24 x 7/8" Self Tapping Screws (2) 1/4" Flat Washer (2) 1/4" x 1 1/4" Fender Washer

UNLESS OTHERWISE SPECIFIED:

REMOVE ALL BURRS AND SHARP EDGES

DIMENSIONS ARE IN INCHES CONCENTRIC .006 TIR .060 TIR ANGLES ± 0° 30' ± 1° 0' x.xxx ± .005 x.xx ± .010 DECIMALS x.x ± .025 ± .015 FRACTIONS ± 1/32 ± 1/16 TOLERANCES MACHINE WELDMENT

COMMENTS:

DO NOT SCALE DRAWING

DESCRIPTION:

DRAWN BY:

CHECKED BY:

DETAIL A

Drill for 1/4" J-bolt

Self drilling screws

Vestil Manufacturing Co.

CADDY INSTALLATION

DATE:

MATERIAL

02/02/05

DATE:

02/02/05

DWG. NO.

SCALE

SHEET 1 OF

020205A

SIZE

REV