Veria Control B35, Control B45 Installation Manual

Veria Control

B35/B45

Installation guide

- 2 - - 3 -

Table of content 1.1 Technical Specications

1 Introduction 2

1.1 Technical Specications 3

1.2 Safety instructions 5

2 Mounting instructions 6
3 Settings 10

3.1 Temperature settings 10

4 Warranty 12

1. Introduction

Veria Control B35/45 is a electronic thermostat provided with
a 2-pole switch and a oor sensor to measure and control the
desired oor temperature. The thermostat is intended for
ush-mounting.
Veria Control is equipped with a LED indicator showing
standby periods (green light) and heating periods (red light).

The maximum temperature setting of the Veria Control B35
Thermostat is 35°C, which makes it ideal for controlling
electrical heating mats beneath or on top of wood oors such
as parquet or laminates.

The Veria Control B45 Thermostat can be used for
temperatures up to 45°C, which makes it ideal for controlling
electrical heating mats on top of concrete or screed oors or
underneath a tile or decorative stone covering.

Operating voltage 180-250 VAC, 50/60 Hz
Contact rating:

- resistive load

- inductive load

250V ~ 15A/3450W

cos ϕ = 0,3 Max. 4A
Sensor NTC 15 kOhm at 25° C
Sensor values:

18°C
20°C
22°C

19,7 kOhm

18,0 kOhm

16,8 kOhm
Switching differential ±0,2° C
Temperature range:

- Veria Control B35

- Veria Control B45

(0) 15-35° C

(0) 5-45° C

Ambient temperature
range

-10º to +30° C

Frost protection
(

)

15º C (B35) / 5º C (B45)

Led Indicator:

- No light

- Red light

- Green light

- Green light ashing

Thermostat off.

Heating mat/cable is active

The desired set point tempe-

rature has been reached.

Floor sensor is faulty
Protection rating IP 31

Dimensions & weight 85mm x 85mm & 90 g

- 4 - - 5 -

1.1 Technical Specications

Cable specication max. 1x4mm² or 2x2,5mm²

Ball pressure temperature 75°C

Pollution degree 2 (domestic use)

Type 1C

Storage temperature -20 to +65°C

Protection class

Class II -

The product complies with the EN/IEC Standard “Automatic
electrical controls for household and similar use”:

• EN/IEC 60730-1 (general)

• EN/IEC 60730-2-9 (thermostat)

Produced for:

Veria ApS
Ulvehavevej 44
DK-7100 Vejle
Denmark

Fax: [phone]
E-mail: [e-mail]

1. Safety Instructions

Make sure the mains supply to the thermostat is turned off
before installation.

IMPORTANT:

When the thermostat is used to control a oor heating
element in connection with a wooden oor or similar material,
always use a oor sensor and never set the maximum oor
temperature to more than 35°C.

Please also note the following:

• The installation of the thermostat must be done by
an authorized and qualied installer according to local
regulations.

• The thermostat must be connected to a power supply
via an all-pole disconnection switch.

• The sensor is to be considered as live voltage. Have this
in mind if the sensor must be extended.

• Always connect the thermostat to continuous power
supply.

• Do not expose the thermostat to moisture, water, dust,
and excessive heat.

1.2 Safety Instructions