Veracity OUTREACH Max, OUTREACH Lite Installation Manual

Page 1
Multiply your PoE network range
OUTREACH MAX and OUTREACH LITE let you instantly extend your Ethernet network installation beyond its 100 metre (328 foot) limit.
Because they use Power over Ethernet (PoE) technology, OUTREACH MAX and OUTREACH LITE can be easily fitted wherever network extension is required, with no need for a local power source.
OUTREACH MAX extends Cat5e, Cat 6 or similar network connections to devices that use PoE power, such as IP cameras and wireless access points:
OUTREACH LITE extends network connections to devices that do not use PoE, such as PCs and routers:
As OUTREACH MAX and OUTREACH LITE restore the Ethernet connection every 100 metres (328 feet), full-capacity 100BASE-TX or 10BASE-T is maintained across the entire link, with no bandwidth restrictions.
Connections and mounting
Technical specification
Device power 1.3 watts
Forwarded PoE power (MAX only)
PoE forwarding of up to 70 watts depending on standard Maximum current 0.7 amps on data pairs Maximum current 1.5 amps on spare pairs
PoE standard IEEE 802.3af / 802.3at / custom PoE compatible (MAX)
IEEE 802.3af Class 2 powered device (LITE)
Ethernet Two independently auto-configuring ports:
- 10BASE-T or 100BASE-TX
- Half or full-duplex; maintains 200Mbit/s link bandwidth
- Patch or crossover cables
Dimensions 105 x 40 x 22 mm ( 4.13 x 1.57 x 0.87” ) LxWxH
Weight 70g ( 2.5 oz )
Environmental Operating temperature: -10 to 50OC ( 14 to 122OF )
Humidity: up to 85%, non-condensing
LED indicators – both connectors
Network status PoE Status
On Link On PoE power enabled
Flashing Activity Off PoE not enabled
Off No link
Note that the LEDs on OUTREACH MAX will not light until the PoE source and powered device are both connected
If the powered device is disconnected, then the OUTREACH MAX should also be disconnected from the PoE power source. OUTREACH MAX should
not be connected to equipment that is not PoE compatible.
Maximum extension distance
By installing an OUTREACH MAX for every extra 100 metres of cable, PoE and Ethernet can be extended for considerable distances, with no bandwith restrictions or any requirement for electrical power installation.
The maximum distance from the PoE source to the IP camera or other device depends on how much PoE power the device requires:
Maximum range, for PoE power (watts)
PoE Source 0W15W 10W 15W 20W 25W
PoE switch
800m
2625ft
450m
1476ft
300m 984ft
N/A2N/A2N/A
2
OUTSOURCE
1150m 3773ft
800m
2625ft
400m
1316ft
N/A2N/A2N/A
2
PoE Plus switch
800m
2625ft
600m
1969ft
400m
1316ft
300m 984ft
200m 656ft
100m 328ft
3
OUTSOURCE PLUS
1150m 3773ft
800m
2625ft
550m
1804ft
400m
1316ft
300m 984ft
200m 656ft
1. Non-PoE applications; using an OUTREACH LITE at the end of the chain
2. Not applicable; these power levels are for PoE Plus source and devices only
3. Extension is not possible at this power level with this power source
These figures are strict upper limits for installations using regular 24AWG Cat 5e cable. Because actual power use and installed cable distances can vary, using OUTSOURCE or OUTSOURCE PLUS is always recommended.
OUTSOURCE is an enhanced PoE injector and is fully compliant with the IEEE 802.3af standard. OUTSOURCE PLUS is an enhanced PoE Plus injector and is fully compliant with the IEEE 802.3at standard.
The distance limits for extension at other peak power levels can be checked using the graph below:
Non-standard PoE
OUTREACH MAX can be used with many implementations of PoE that are not IEEE 802.3af or 802.3at compliant. This includes high-current PoE, or PoE which is “always-on” or uses a proprietary signature.
Four-pair PoE, in which current is carried on both spare and data pairs to double available power, is also supported. See application notes.
INSTALLATION MANUAL
PLEASE READ CAREFULLY
7mm (0.2 8” ) moun ting hol es
ce ntres 8 9m m (3.5”) apa rt
10 /100
network
conne ction
PoE in from
mids pa n
injecto r
or PoE switch
10 /100
network
conne ction
PoE out to
powered
device
eg. IP ca me ra
(MAX only)
Page 2
EC Declaration of Conformity
In accordance with EN 45014:1998
We, Veracity UK Ltd. of 6 Barns Str eet, Ayr, KA7 1XA declare that the equipment “OUTREACH” Ethernet repeaters model number VOR-ORM / VOR-ORL conform t o the essential protection requirements of the EMC Dire ct ive 89/336/EEC as amended.
The following EMC standards hav e been applied:
BS EN 55022:1998 Emissions (Class B Radiated) BS EN 55024:1998 Immunity (BS EN 61000-4-2:1995 Immunity to ESD, BS EN 61000-4-3:2000 Immunity to Radiated RF Fi elds (3V /m))
I hereby declare t hat the equipment named above has been been found to comply wit h the relev ant sections
of the above referenced specifi cations. The unit complies with all essential requirements of the EMC Directiv e.
Responsible Person Mr Alastair McLeod, Director
Issued 9th October 2009 at Ayr
This device complies with Part 15 of the FCC Rules. Operation is subject to t he following
two conditions: (1) this devi ce ma y not cause harmful interference, and (2) this device
must accept any interference received, including inter fer ence that may ca use undesired
operation.
NOTE: This equipment has been tested a nd found to comply w ith the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits ar e designed to provide reasonable protection agai nst
harmful interference when the equipment is operat ed in a commercial environment. This equipment
generates, uses, and can radiat e radio frequency energy and, if not instal led and used in accordance
with t he instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is lik ely to cause harmful interference in which case the user will be
required to correct the i nterference at his own expense.
Example OUTREACH MAX / OUTREACH LITE applications
1. Delivering 20 watts to a PoE Plus device over 300 metres (984 feet)
More than one OUTREACH Ma x may be co nne cte d i n s eries to exten d PoE and Eth e rne t for s evera l h un dred metres . In th e e xa mp l e a bove , Veracity's OUTSOURCE PLUS inje ctor is used to a dd en hance d PoE Plus capa bility to a regu l a r un powere d ne twork p ort. Two OUTREACH MAX units a re loca ted 100 me tre s a nd 200 metres from th e s witch, a ll owi ng a PoE Pl us wi reless a cce s s poi nt to be ins ta l l ed up to 300 me tres from the power source.
2. Extending an unpowered network connection to 200 metres (656 feet)
The combina tion of Vera ci ty's OUTSOUR CE e nh a nced PoE i njector a nd OUTREACH LITE Eth e rne t ran ge extend e r del ivers a s impl e a nd re l ia ble me a ns to exten d LAN ca bl i ng beyond i ts 100 metre li mi t. By con necting a s ingl e OUTREACH LITE a fte r 100 metres of cabl ing, the con nection from n e two rk s witch p ort to wa l l outl et may exte nd up to 200 me tres. OUTSOURCE delivers power to the OUTREACH LITE, a nd ma y be con ven i e ntly loca ted ne a r the network s witch.
3. Combining OUTREACH LITE and OUTREACH MAX to deliver an unrestricted network connection beyond 200 metres
For exten ding data-onl y conne cti ons , wh ere no PoE i s requi red for th e e nd d e vice, a combina tion of OUTREACH MAX a nd OUTREACH LI TE ma y be u s e d to incre a s e ra nge beyond 200 metres . The OUTREACH MAXes forwa rd bo th da ta and PoE from the PoE s wi tch to the p owe red d e vice, which i n this ca s e i s the OUTR EACH LI TE. The total di s ta nce from s witch to outl et i n the exa mp l e i s up to 400 me tres (1316 fee t). Unres tricted 100Ba s e -T full-dup l e x (to ta l b a ndwidth 200Mbi t/s) connection s o f up to 2200 me tres (7218 feet) betwe e n po we r s ources a re po s s i ble us ing th i s metho d.
4. Versatile network expansion with distributed PoE using OUTREACH QUAD
In th i s e xamp l e a n OUTREACH MAX is used to forwa rd enh a nced PoE Pl us power to a n OUTR EACH QUAD PoE-forwa rding s wi tch, l ocated u p to 200 me tres from th e n etwork s witch a nd OUTSOURCE PLUS i njector. The OUTREACH QUAD exten ds the PoE a nd ne twork con necti on a further 200 me tre s to a n IP came ra us i ng OUTREACH MAX, and provi de s a PoE n e two rk p ort for a VoIP phone , pl us an a ddi tiona l two ne twork con necti ons for o the r device s or for con nection to a l ocal ne two rk.
Loading...