Velleman WELD-961 User Manual [en, de, es, fr]

W
WELDING TORCH CHALUMEAU DE SOUDAGE LASBRANDER SOPLETE SOLDADOR SCHWEIßBRENNER
USER MANUAL NOTICE D’EMPLOI GEBRUIKERSHANDLEIDING MANUAL DEL USUARIO BEDIENUNGSANLEITUNG
1. Introduction
To all residents of the European Union Important environmental information about this product
local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before bringing this device into service. If the device was damaged in transit, don't install or use it and contact your dealer.
These torches are high-quality products tested individually and guaranteed in order to provide safe and excellent performance. Note that the connection to the gas cylinder must be made with a rubber hose approved by the laws of the country of use.
2. Before Use
Make sure the rubber hose in good condition, the connection of the rubber hose to the cylinder with hose clamps is tight and that the rubber can withstand the pressure.
3. Ignition
Open the cylinder tap and turn on slowly the tap of the torch. Bring a flame just under the burner.
4. Use
Adjust the flame intensity by opening or closing the tap. In case the device is provided with an opening lever, reduce the flame to its minimum by turning the knob and operate the lever to get the suitable flame intensity. The lever’s release involves an automatic and immediate return to the minimum flame setup.
5. Maintenance
The use of dirty gas coming from the cylinder bottom may cause a partial blocking of the jet. To clean it, remove the burner and the injector, and wash carefully with gasoline or a similar product, or with thin wire. Do not widen the injector.
6. Interchangeable Burners
In case the instrument is supplied with interchangeable burners or you need additional ones, remove the installed burner from the device together with the hexagonal adapter and assemble the new one. Pay attention to the fit of the aluminium washer.
The WELD-961 is supplied with 40mm flat burners and 20mm welding and soldering burners. They must be tightened up directly to the 17mm burner installed in the torch.
7. Important
Do not pull the rubber hose if connected to the gas cylinder. Verify the condition of the hose before use. Replace it if damaged, cut or overheated. The hose must be changed within the expiring date printed on the hose.
Velleman nv cannot be held responsible in the event of damage or injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.perel.eu. The information in this manual is subject to change without prior notice.
WELD-961 – WELDING TORCH
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized company for recycling. This device should be returned to your distributor or to a local recycling service. Respect the
Loading...
+ 5 hidden pages