4 CHANNEL USB RECORDER / LOGGER
PCS10 / K8047
USB driver installation
instructions
USB driver installationI
Table of Contents
Part I English
3
................................................................................................................................... 31 USB driver installation
.......................................................................................................................................................... 3fig1
.......................................................................................................................................................... 4fig2
.......................................................................................................................................................... 4fig3
.......................................................................................................................................................... 5fig4
.......................................................................................................................................................... 5fig5
.......................................................................................................................................................... 5fig6
I
USB driver installation3
1 English
1.1 USB driver installation
Start by inserting the included PC-LAB2000 CD in your PC and executing the installation procedure
that will install the PC-LAB2000 on your hard disk. You may already be using PC-LAB2000 with
another one of our other products (PCS100,PCS500,PCG10,..). Make sure you are using Rev 1.30 or
higher.
1.1.1 fig1
Use the included USB cable to link the K8047/PCS10 to your computer's USB interface connector.
Click on the screen button "NEXT" to install the H.I.D. USB driver if necessary. Check if the green LED
(POWER) lights
1.1.2 fig2
English 4
Click on "NEXT" again
1.1.3 fig3
Indicate the location of the Windows 98 SE CD or the Windows 98 SE driver files (*.CAB)
© 2003 Velleman Components
1.1.4 fig4
Put your original Windows 98 SE CD in your CDROM drive if necessary
1.1.5 fig5
USB driver installation5
Indicate the correct location of the driver files if this is not taken care of automatically
1.1.6 fig6
The installation of the driver is succesful if the next screen is displayed.
Click on "Finish"
Velleman Instruments is a division of
Velleman Components NV.
Legen Heirweg 33
9890 Gavere
Belgium
Internet site : http://www.velleman.be
E-mail : support@velleman.be
© Velleman Instruments 2003_UK
Loading...