Vectronics DC-35 Instruction Manual

VECTRONICS

READ ALL INSTRUCTIONS BEFORE OPERATING THIS EQUIPMENT !

Thank you for purchasing the DC-35 High Current DC Outlet. The DC-35 is very versatile in allowing
you to channel power to two HF or VHF radios and as may as six different ham radio accessories at the
same time. The DC-35 alleviates the problem of multiple connections to the same DC power supply
terminals.

The DC-35 has six sets of binding posts for station accessories. A front mounted rocker switch controls
power to these outlets. A 15 amp master fuse protects your accessories and a LED indicates switched
power on. Each pair of 35 amp heavy duty binding posts is individually fused to 35 amps. Fuses are
accessed through the back of the unit. The voltage meter monitors output voltage from your power
supply and a LED indicates power "ON". All connections are RF bypassed to reduce line noise.

Power Rating

The unswitched binding posts on the DC-35 can handle up to 35 amps each but should not have a
combined total of over 35 amps. The switched accessory outlets can handle 5 amps each but should no
carry over a maximum combined total of 15 amps. It is the operators responsibility to insure that all
equipment connected to the DC-15 falls within connection power ratings.

The DC-35 can not be used for AC applications. The DC-35 does not regulate voltage or power in any
way. The output to equipment is dependent on the power supply output. The maximum voltage is 24
volts at 17.5 amps for unswitched outlets or 7.5 amps for switched accessory outlets.

Installation

DC-35 High Current DC Outlet

WARNING: Reversing the (+) and (-) leads will damage station equipment !

Connect the two leads of the DC-35 to your DC power supply. The red (+) cable should be connected to
the positive (+) terminal and the black (-) cable connects to the negative (-) terminal of the power supply.
A ground wire should be connected form the station ground bus to the ground terminal on the case of the
DC-35. Due to the high current involved the ground wire should be of appropriate length and gauge for
safety to equipment and the operator.