Ubiquiti Networks airGateway User Manual

Indoor Access Point with
External Antenna

Model: airGateway-LR

Introduction

Thank you for purchasing the Ubiquiti Networks™ airGateway™.
This Quick Start Guide is designed to guide you through
the installation, and show you how to access the airOS®
Configuration Interface. This Quick Start Guide also includes
the warranty terms and is for use with the airGateway LR.

Package Contents

POE LAN

airGateway LR External Antenna Wall Mount Bracket

Indoor Access Point with
External Antenna

Screws

(M2.9x20, Qty. 2)

Products may be different from pictures and are subject to change without notice.

TERMS OF USE: All Ethernet cabling runs must use CAT5 (or above). It is the customer’s
responsibility to follow local country regulations, including operation within legal frequency
channels, output power, indoor cabling requirements, and Dynamic Frequency Selection
(DFS) requirements.

Screw Anchors

(M2.9x20, Qty. 2)

Model: airGateway-LR

Quick Start Guide

Hardware Overview

Top

RJ45 Connector

(Male)

Antenna

Connector

LED

POE LAN

PoE
Port

LAN
Port

LED

Steady White Indicates bootup/initializition/power-on.

Steady Blue Indicates the airGateway is working properly and

an active connection is detected.

Alternating Blue/White Indicates the device is busy; do not

move or unplug.

Bottom

Reset

Mounting

Tabs

Reset Resets the airGateway to factory defaults. To reset the

airGateway, press and hold the Reset button for more than five
seconds while the airGateway is powered on.

Reset Ext Resets the airMAX® CPE device connected to

the airGateway to factory defaults. To reset the airMAX
device,press and hold the Reset Ext button for more than five
seconds while the airMAX device is powered on.

Reset

Ext

Installation Requirements

POE

LAN

The airGateway is powered by and integrates exclusively with
Ubiquiti Networks PoE adapters. A wall mount kit is included.

• Ubiquiti Networks PoE Adapter (24V, 0.5A)

• Ubiquiti Networks airMAX CPE device

• CAT5/6 cable

• 6 mm drill bit and drill

• Screwdriver

Hardware Installation

WARNING: Do not connect non-PoE devices (such as

laptops) to the POE port.

To install the airGateway, perform the following steps:

1. Disconnect the Ethernet cables from the Ethernet ports
on the PoE Adapter connected to your airMAX CPE device.
Ensure that you note which cable was connected to the
POE port and which cable was connected to the LAN port.

2. Insert the male RJ45 Connector of the airGateway into the

POE

LAN

POE

LAN

POE

LAN

POE

LAN

Ethernet port labeled POE on the PoEAdapter. Push the
two units together until they connect.

3. Connect the Ethernet cable that was disconnected from the
POE port in step 1 to the POE port on the airGateway.

*720-00066-01*

720-00066-01

4. Connect the Ethernet cable that was disconnected from the

POE

LAN

POE

LAN

LAN port in step 1 to the LAN port on the airGateway.

5. Connect the External Antenna to the Antenna Connector on

the airGateway.

POE

POE

LAN

LAN

Wall Mounting

1. Position the Wall Mount Bracket at the desired location
on the wall with the bubble level at the bottom. Use the
bubble level to ensure the bracket is plumb.

2. Mark the two holes with a pencil.